User manual DELONGHI EMK 2

[. . . ] The coffee maker must be operated exclusively by plugging into the electrical supply and never by resting it on lit gas rings or hot plates. Never touch the appliance with wet or damp hands or feet. Never let children or unfit persons use the appliance without supervision. Make sure children do not play with the appliance. [. . . ] To prepare half the coffee maker, insert the adapter disc (G) in the funnel filter (fig. · Fill the funnel filter with ground coffee, without pressing down (fig. Fill it a little at a time to avoid the ground coffee overflowing. 10 · Distribute the ground coffee uniformly and remove any excess coffee from the edge of the filter. IMPORTANT: Use good quality, mediumground coffee, for moka coffee makers. · Tighten the coffee maker firmly but without exaggerating, holding the boiler with one hand and turning the carafe clockwise with the other, without pushing on the handle. IMPORTANT: to avoid dangerous splashes of boiling water, never use the coffee maker unless the disk filter (D) is correctly in position. · Rest the coffee maker on the base (Fig. Manual start-up · Press the START/STOP button (S). The indicator light (Z) comes on to indicate that the coffee maker is operating. The indicator light (Q) on the other hand indicates that the Keep Warm function is activated. If you do not want this function, press the Keep Warm button (R). · Coffee delivery will begin after a few minutes. · When all the coffee has been delivered, the word "END" appears on the display accompanied by three beeps. The indicator light (Z) goes off after a few minutes. To remove the word "END", press any button and wait for a few minutes. Programmed start-up · Once the coffee maker has been prepared, press the "Timer On" (V) button. After programming the required start-up time, the "programmed start-up" (U) and "Keep Warm" (Q) indicator lights come on. (If you want to deactivate the "Keep Warm" function, press the " " button again). · At the programmed time, the appliance emits a series of beeps, the "programmed start-up" indicator light (U) goes off and the indicator light (Z) comes on showing that the appliance has begun to heat the water. · When all the coffee has been delivered, the word "END" appears on the display and the appliance emits 3 beeps. After a few minutes the indicator light (Z) goes off and the "Keep Warm" indicator light (Q) remains on. · Press any button to eliminate the "END" display. If there is no water in the boiler or if the coffee maker is not correctly positioned on the base, the display "H2O" appears accompanied by a long beep. [. . . ] Make sure the coffee maker is cold and unscrew (fig. Make sure the inside of the boiler is completely clean. Make sure the boiler is cold and NOT in place on the base. After half an hour, empty the boiler and make sure the scale has gone from the bottom. [. . . ]