User manual DELONGHI FAN HEATER HVM023C

[. . . ] WARNING: Very carefully dispose of the cut off plug after removing the fuse: do not insert in a 13 Amp socket elsewhere in the house as this could cause a shock hazard. With alternative plugs not incorporating a fuse, the circuit must be re-fitted when changing the IMPORTANT The wires in the mains lead are coloured in accordance with the followin code: Blue: Neutral Brown: Live As the colours of the wires in the mains lead of this appliance may not correspond with the coloured fuse using a 13 Amp Asta approved fuse to BS 1362. In the event of losing the fuse cover, the plug must NOT be used until a replacement fuse cover can be obtained from your nearest electrical dealer. [. . . ] Heating at low power: turn the knob to the 1 position. Heating at maximum power: turn the knob to the 2 position. Setting the thermostat: when the room temperature has reached the desired level, slowly turn the thermostat dial counter-clockwise until the pilot light goes out (or until you hear a `click' on models without pilot light) but no further. The thermostat will now automatically maintain the temperature at the desired level. Switching the heater off: turn the knob to the " q " position. To switch off completely the appliance, remove the plug from the socket. MODELS WITH 24 HOUR PROGRAM UNIT (TIMER) In order to program the heating function, proceed in the following manner: Look at your watch. If it, for example, indicates that the time is 6 PM (18 hours), then turn the numbered disk of the program unit clockwise until the number 18 lines up with the reference marker q on the face of the timer. Set the time periods in which the appliance is to function, pulling out the pins of the timer. At this point you will see the sectors which correspond to the functioning times. Once the appliance is set in this manner, it will function automatically every day during the programmed periods. Important: In order to maintain the programming, it is necessary to keep the electric plug inserted in the electric socket. In order to change the programming, put the pins back into their original positions and set the functioning periods from scratch. Each pin corresponds to a 30 minute period. Bypassing the program: In order that the appliance functions outside of the programmed periods, pull out all of the timer's pins. Anti-freezing feature: With the knob of the thermostat in position , the appliance maintains the room at a temperature of about 5°C, thus preventing freezing with a minimal expenditure of energy. With the models equipped with a timer, the pins must be pulled out. MAINTENANCE ALWAYS pull the plug out of the power point before cleaning the heater. [. . . ] The appliance must not be positioned directly underneath a fixed power point. Do not cover the appliance while it is functioning in order to avoid overheating with the attendant risk of fire. The heater is fitted with a safety device which will switch off the heater in case of accidental overheating (eg. [. . . ]