User manual DELONGHI HCM 2020

[. . . ] The appliance must not be placed directly under a fixed socket. · Do not rest the power cable on the appliance when hot. · Always use the heater in a vertical position only. · Do not obstruct the hot air outlet grilles or the air intake grille on the bottom or top of the appliance. [. . . ] At the end of its working life, the product must not be disposed of as urban waste. It must be taken to a special local authority differentiated waste collection centre or to a dealer providing this service. Disposing of a household appliance separately avoids possible negative consequences for the environment and health deriving from inappropriate disposal and enables the constituent materials to be recovered to obtain significant savings in energy and resources. As a reminder of the need to dispose of household appliances separately, the product is marked with a crossed-out wheeled dustbin. HOW TO USE YOUR CONVECTOR ASSEMBLING THE FEET - Fit the feet to the appliance as follows: - Fasten the feet in position using the screws supplied (see fig. OPERATION AND USE Turning the appliance on Models with thermostat only This appliance can be turned on by rotating its thermostat knob (A) clockwise until it stops at the last possible setting (fig. To turn this appliance off, rotate the knob to its lowest position and remove its plug from the electrical outlet. Models with a thermostat and two switches Turn the thermostat knob clockwise (A) until it reaches its last possible setting, then press one switch (minimum power) or both switches (B) (maximum power) so the part of the switch area becomes visible (fig. Adjusting the thermostat When the room has reached the desired temperature, turn the thermostat knob slowly in an anti-clockwise direction until you get to the setting -- and not beyond it -- where you hear a click. The thermostat will then adjust that set temperature automatically and keep it constant. If your appliance is the type with 2 switches, you could utilize only one of them during mild seasons and on days not particularly cold. You will thus use little electrical power and obtain even greater savings in energy consumption. Frost protection function (only for models with a thermostat) Turn the switch (or switches) to make the red area show, then turn the thermostat knob to the " " setting. When so regulated, this appliance will keep a room at a temperature of 5° C. while consuming a minimum of energy. Electric Convector Heating HCM 4 Wall-mounting IMPORTANT: Before drilling into any wall ensure no electrical cables are present in the area. In order to wall mount your convector please proceed as follows: 1. Fix two brackets "C" following carefully the dimensions as indicated in description (fig. Use a 6 mm masonry drill and suitable wall plugs and appropriate two screws and two brackets (provided). Hang the convector on the two brackets fixed to the wall and insert metal bracket "D" into the bottom rear section of the base of the convector as indicated in figure 4. Mark the positions for fixing these brackets to the wall. [. . . ] Never use abrasive powders or solvents. Fig. 4 5 Electric Convector Heating HCM Important - UK only · The wires in the cord are coloured as follows: Green and Yellow = Earth Blue = Neutral Brown = Live. The appliance must be protected by a 13A approved (BS1362) fuse. warning: this appliance must be earthed. For non-rewireable plugs the fuse cover MUST be refitted when replacing the fuse. [. . . ]