User manual DELONGHI HI R

[. . . ] Read the instructions book carefully and keep it in a safe place. This appliance requires a rubber tube and a pressure regulator in accordance with the law in force. If not supplied check with your gas supplier. This appliance MUST NOT be used in basements, high rise flats, bathrooms or bedrooms and in rooms having volume less than 15 m3 (30 m3 in living rooms). [. . . ] DO NOT use the heater again until it has been inspected by your Dealer. NEVER USE MATCHES TO FIND LEAKS. 7 GB 26-08-2003 16:02 Pagina 8 ASSEMBLY 1) Remove the polystyrene fixing the heater base plate and the heater front panel. Remove the heater base plate from the polystyrene. Place the heater base plate on the floor or on a flat surface. Remove the two screws from the holes "A" (fig. 5). Tabs B Holes A fig. 5 Tabs B 2) Position the heater's front panel assembly over the base plate, and align the four tabs "B" on the base with the four slots "C" (fig. 6) in the bottom of the front panel assembly. With the four tabs correctly engaged, push the front panel assembly forwards as far as the tabs will slide in their slots to align the screw holes "A" in the base plate with the screw holes "D" in the bottom of the front panel assembly. 6 3) Fit the front panel assembly to the base plate by fixing the two screws (fig. 7) (removed previously) trough the aligned screw holes (holes D and A). Place the gas cylinder in the gas cylinder compartment and connect the regulator to the cylinder as shown on page 4. Holes D Slot C Screw fig. 7 4) Finally, fit the flexible rear panel. First, engage the two clips located on the top cover, in order to bend the panel and fix it into shape. Then insert the six tabs in the six slots at the rear of the heater body Attention: to unhook press on the relevant clips (fig. 8). Top cover clip Lower cover Clip Tabs Top cover Lower cover Tabs fig. 8 8 GB 26-08-2003 16:02 Pagina 9 GENERAL SAFETY INSTRUCTIONS Gas bottle Gas Bottle with 15 kg of maximum capacity can be installed. Changing of gas bottle must not be carried out in the presence of a naked flame. Use the gas bottle always in upright position. If a screw on regulator is used ensure that the regulator washer is present and in good condition -replace if in any doubt. To place the bottle in position, remove the rear panel which faces the inside during transport, by unfastening the screws; than put the bottle in position and replace the panel. Do not turn the bottle upside down to use completely its content. Pressure regulators, rubber tubes and clips CHECK that tubing is completely over the nozzles at each end of the tubing and that it is held firmly in place by tube clips (See fig. 9). Examine flexible tubing regularly and get your Dealer to fit new tubing 400 mm long complying to local standard, if perished, worn or damaged. In any case replace the tube every 5 years. [. . . ] Check that there is no dust blocking the air inlet or outlet grids. When not in use remove plug from socket and store cable as shown in Fig. When not in use the heater should be covered and stored in a dust-free place. Refer any major maintenance to an authorised service center. [. . . ]