User manual DELONGHI HIR 2

[. . . ] DO NOT position heater alongside a wall or near curtains or arm-chairs etc. 1 - - ALWAYS face heater towards centre of room. Special care should be taken if the heater is on a surface where it can move or twist on its wheels or castors if knocked by a child or dog, etc. Minimum Clearance : 200 mm from sides, 1500 mm from front. [. . . ] 5 Tabs B 2) Position the heater's front panel assembly over the base plate, and align the four tabs "B" on the base with the four slots "C" (fig. 6) in the bottom of the front panel assembly. With the four tabs correctly engaged, fig. 6 push the front panel assembly forwards as far as the tabs will slide in their slots to align the screw holes "A" in the base plate with the screw holes "D" Holes D in the bottom of the front panel assembly. 3) Fit the front panel assembly to the base plate by fixing the two screws (fig. 7) (removed previously) trough the aligned screw holes (holes D and A). Place the gas cylinder in the gas cylinder compartment and connect the regulator to the cylinder as shown on page 4. Slot C Screw fig. 7 Top cover 4) Finally, fit the flexible rear panel. First, engage the two clips located on the top cover, in order to bend the panel and fix it into shape. Then insert the six tabs in the six slots at the rear of the heater body Attention: to unhook press on the relevant clips (fig. 8). clip Lower cover Clip Tabs Top cover Lower cover Tabs fig. 8 3 GB 21-07-2003 16:05 Pagina 4 GENERAL SAFETY INSTRUCTIONS Gas bottle Gas Bottle with 15 kg of maximum capacity can be installed. Changing of gas bottle must not be carried out in the presence of a naked flame. Use the gas bottle always in upright position. If a screw on regulator is used ensure that the regulator washer is present and in good condition -replace if in any doubt. To place the bottle in position, remove the rear panel which faces the inside during transport, by unfastening the screws; than put the bottle in position and replace the panel. Do not turn the bottle upside down to use completely its content. Pressure regulators, rubber tubes and clips CHECK that tubing is completely over the nozzles at each end of the tubing and that it is held firmly in place by tube clips (See fig. 9). Examine flexible tubing regularly and get your Dealer to fit new tubing 400 mm long complying to local standard, if perished, worn or damaged. In any case replace the tube every 5 years. 9 When connecting the pressure regulator to the gas bottle avoid undue twisting of the flexible tubing. A 28 ÷ 30 mbar (11. 2 in w. g. ) pressure regulator for Butane or Propane complying to local standard must be connected to the appliance with the above tubing, using suitable tube clips. Ventilation USE ONLY IN A WELL VENTILATED ROOM Adequate ventilation must be provided in rooms in which the heater is used. This ensures removal of the products of combustion and allows the entry of replacement air. The following table shows the smallest size of room suitable for each heat setting and the dimensions of the aperture which must be provided equally divided between high and low level, according with the maximum, medium or minimum power. Room Size Room Aperture 42 m3 105 cm 2 Safety guard The guard is to prevent risk of fire and no part of it should be permanently removed. [. . . ] Never operate the appliance with the large knob held downwards by force. MAINTENANCE Wipe your appliance with a soft damp cloth and only when it is switched off, cold and unplugged. Do not use solvents or abrasives detergents. Check that there is no dust blocking the air inlet or outlet grids. [. . . ]