User manual DELONGHI HMP 1500

[. . . ] Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has been dropped or damaged in any manner. Return heater to authorized service facility for examination, electrical or mechanical adjustment, or repair. This heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never locate heater where it may fall into a bath tub or other water container. [. . . ] Do not assemble the feet if wall mounting. Electrical connection - Before plugging in the appliance, check that your supply voltage is the same as that shown on the rating plate of the Appliance and that the power supply is able to with stand the power consumption (Watts) shown on the rating plate. - If using more than one appliance at a time, it is important to ensure that the power supply is able to with stand the Free standing operation To fit the feet to the appliance, proceed as follows: Fix the foot with the supplied screws, as shown in fig. CAUTION: Never use this heater without feet when not wall-mounted. ASSEMBLY KIT The wall mounting kit contains: 4 x screws for wall mounting 4 x anchors (0. Wall-Mounting Installation Before installing the unit , make sure of the following: a. The heater is not located directly below a power outlet. The power outlet can be easily reached by the plug and after installation. No electric cables or other pipes could be damaged during the installation. Keep away from curtains or inflammable materials. to wall-mount , proceed as follows: For brick walls use a 15/64" (6 mm) concrete drill bit . For plaster board or false (hollow) walls, it is recommended to use appropriate screws and anchors (not supplied). Before drilling the wall, mark out a template using the mounting bracket respecting the minimum distances as Drill the wall where previously marked, and insert the plastic anchors. Fix the bracket with the 2 screws provided (see fig. Mark out the 2 lower fixing points (fig. Remove the appliance, drill the lower holes and insert the wall anchors. Now, you can hang back the heater to the bracket and fix the lower part of the appliance with the 2 remaining Functioning and use - Insert the plug into the mains. - Turn the thermostat knob in a clockwise direction until it reaches the 6 setting. - Minimum power (750W): turn the function knob to setting "MIN" (the pilot light will light on). - Maximum power(1500W): turn the function knob to setting "MAX" (the pilot light will light on). - Switching off: turn the function knob to setting"OFF" and remove the plug. Adjusting the thermostat Turn the thermostat knob in a clockwise direction until it reaches the maximum setting (6). [. . . ] If repairs become necessary, see contact information below: Residents: Please contact our toll free hotline at 1-800-322-3848 or log onto our website at www. Residents of Canada: Please contact our toll free hotline at 1-888-335-6644 or log onto our website at www. Residents of Mexico: Please contact our toll free number 01-800-711-8805 for assistance or log onto our website at www. The above warranty is in lieu of all other express warranties and representations. [. . . ]