User manual DELONGHI HMW 2000 T

[. . . ] Make sure that no pieces of polystyrene or other packaging material have been left between one element of the appliance and another. Check that the neither the appliance not the power cable have been damaged in any way during transportation. FITTING THE FEET Remove the feet and the castors from the polystyrene packing. Turn the heater upside-down an a soft surface in order to prevent damaging the paint finish. [. . . ] Except on particularly cold days, it is generally not necessary to select maximum power; one of the lower power setting should be sufficient in milder weather. 3) To set the heating periods proceed in the following manner: Setting the Timer- if fitted Set the timer correct time. turn the numbered dial of the time-clock in a clockwise direction until the number 11 coincides with the reference mark s on the clock. Set the time period during which you wish the appliance to work by pushing the notches towards the centre. Each notch corresponds to a 15 minute period. At this point sections will be visible, corresponding to the working periods. Once the lever has been positioned on the heater will automatically work only during the preset time in periods. (Important: the plug must remain connected to power supply). To change programmed operating times, just pull notch back to original position and reset timer for new functioning period. To override the timer, place the lever in position . MAINTENANCE Your oil filled radiator is absolutely free from maintenance, fully reliable and will give many years of trouble free service. Occasionally wipe heater with soft damp cloth, do not use detergents or abrasives. If necessary, use a vacuum cleaner to remove any built-up dirt (fig. 4). IMPORTANT NOTES · Do not use this heater in the immediate surroundings of a bath, a shower or a swimming pool. · Do not lay the cable on the hot unit. · Use of extension leads should be avoided. · The heater must always work in a upright position. · when using the appliance for the first time, switch it on for al least 2 hours with the thermostat in the maximum position in order to eliminate the "new" smell that is typical of all new appliances. Ensure that the room is well ventilated. · It is normal for the appliance to emit small crackling sounds when you first turn it on. [. . . ] 5710007600/10. 03 ATTENTION: in order to avoid any danger caused by an accidental resetting of the safety system, this appliance must not be powered through an external timer. CAUTION: Do not cover the appliance during operation, this will cause over-heating. See fig. 5 for correct use of drying function. An over temperature cut out device is fitted for your safety. [. . . ]