User manual DELONGHI HVE 333.2

[. . . ] WARNING: Very carefully dispose of the cut off plug after removing the fuse: do not insert in a 13 Amp socket elsewhere in the house as this could cause a shock hazard. With alternative plugs not incorporating a fuse, the circuit IMPORTANT The wires in the mains lead are coloured in accordance with the followin code: Blue: Neutral Brown: Live must be re-fitted when changing the fuse using a 13 Amp Asta approved fuse to BS 1362. In the event of losing the fuse cover, the plug must NOT be used until a replacement fuse cover can be obtained from your nearest electrical dealer. [. . . ] OPERATION AND USE Foot switch This appliance is fitted with an ON/OFF foot switch. Set the thermostat and your chosen function following the instructions below, and. simply press the foot switch to start the appliance working. To switch it off, simply press the foot switch again. The power plug should be removed from the wall socket when the appliance is not in use. IMPORTANT The appliance can only be started when the foot switch is ON OPERATING THE FUNCTON SELECTOR AND THERMOSTAT (Fig 1) - Turn the thermostat dial fully clockwise to the maximum position - Summer use: (ventilation only): turn the dial to position - Reduced power heating: turn the function selector to position 1. - Full power heating: turn the function selector to position 2. - Switching off: turn the function selector to position 0. SETTING THE THERMOSTAT When the room has reached the desired temperature, slowly turn the thermostat dial anticlockwise, until the appliance switches off and not beyond. The temperature fixed in this way will be automatically regulated and kept constant by the thermostat. FROST STAT FUNCTION Switch on the appliance by pressing the foot switch. It is recommended to select the full power setting (2 on the function selector), and then turn the thermostat dial in position The appliance will maintain a minimum room temperature of approximately 5°C to prevent freezing with a minimum energy consumption. AIRFLOW DIRECTION THE APPLIANCE CAN BE ADJUSTED AND INCLINED MANUALLY SO AS TO AIM THE FLOW OF AIR IN THE DESIRED DIRECTION 5714004300 18-12-2000 14:46 Pagina 4 MAINTENANCE - Before cleaning always switch off and remove the plug from the electrical socket. - Periodically clean the air intake and outlet grilles using a vacuum cleaner. To clean the unit, do not use solvents or abrasive detergents. A soft damp cloth should be used to clean the surfaces of the heater. [. . . ] - Do not cover the appliance while it is functioning in order to avoid overheating with the attendant risk of fire. - Do not use the appliance in rooms less than 4 m2 in area. The heater is fitted with a safety device which will switch off the heater in case of accidental overheating (eg. [. . . ]