User manual DELONGHI HVN 2020

[. . . ] INSTALLATION The appliance can be used either as a portable unit or wall mounted. Models with motorised base cannot be wall mounted. To mount on the wall, proceed as follows: - Fix the bracket to the wall respecting the minimum measurements indicated in fig. If the appliance is installed in a room with bath or shower, respect the "safety distances" shown in fig. [. . . ] To switch the appliance off completely, turn the knob to the minimum position, then unplug from the mains. MODELS WITH 24 HOUR TIMER To programme heating, proceed as follows: Check the time on your clock or watch. If it is 10. 00 for example, turn the numbered programmer disk until the number 10 coincides with the pointer marked on the programmer. Set the periods of time during which you want the appliance to operate by pushing the teeth outwards. Each tooth corresponds to a period of 30 min. The appliance will now function automatically each day at the programmed time (important: the appliance must always be plugged into the mains socket). - To change the programmed time period, just bring the teeth back to their original position and set the new working periods required. 4 - To use the appliance without programming, push all the teeth outwards. In this case, to turn the appliance off completely, also unplug from the mains to avoid the programmer operating uselessly. MODELS WITH SWIVELLING BASE (pedal switch) A number of models have a swivelling base and pedal switch. The appliance can be manually oriented to an angle of 30° to the right or left to direct the air flow in the preferred direction. To turn the appliance on, set the thermostat dial and function selector (and possibly timer) as described above, then press the pedal to turn the main switch on, starting the appliance up. To turn off, just press the pedal again. Important: the appliance can be turned on by pressing the pedal only. MODELS WITH MOTORISED ROTATING BASE Some models have a motorised rotating base and pedal switch. To distribute the air flow over a larger area, press the pedal. The appliance swings from right to left. To stop the appliance in the desired position, simply press the pedal again. MAINTENANCE - Always unplug from the mains socket before cleaning. - Clean the air intake and outlet grilles regularly. - Do not use abrasive cleaning products or solvents. IMPORTANT - Do not use this appliance near showers, baths, swimming pools, etc. [. . . ] To restart the appliance, simply place it upright again. The heater is fitted with a safety device which switches the heater off in case of accidental overheating (eg. obstruction of air intake and outlet grilles, motor turning slowly or not at all). To reset, unplug the appliance from the mains socket for a few minutes, remove the cause of overheating then plug in again. [. . . ]