User manual DELONGHI KH 770510M

[. . . ] If your appliance is not fitted with a plug, please follow the instructins provided below: WARNING - THIS APPLIANCE MUST BE EARTHED IMPORTANT The wires in the mains lead are coloured in accordance with the following code: Green and yellow Earth Blue Neutral Brown Live As the colours of the wires in the mains lead may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The green and yellow wire must be connected to the terminal in the plug marked with the letter E or the earth symbol or coloured green or green and yellow. The blue wire must be connected to the terminal marked with the letter N or coloured black. The brown wire must be connected to the terminal marked with the letter L or coloured red. GENERAL FEATURES Remove the appliance from the packaging, turn upside down and rest on the polystyrene. [. . . ] Check that neither the appliance nor the power cable has been damaged in any way during transportation. do not operate the appliance if damaged 2. FITTING THE FEET Remove the feet and the castors from the polystyrene packing. Fit the castors to the spindles on the feet and push firmly until they click into position (fig. Using the threaded u-bolt and wing nuts, fit the feet to the bottom of the radiator between the last two elements as shown in figures 2, 3 and 4. Depending on the type supplied, type A or type B, mount the feet as shown in figure 5 or 6. Models with "Easy wheel" sytem Turn the radiator upside-down on a rug or a soft surface in order to prevent damaging the paint finish. Turn the radiator back to its upright position. IMPORTANT When in use, the radiator should always be kept vertical (wheels at the bottom, controls at the top). ELECTRICAL CONNECTION - Before plugging the radiator into the mains, check that the voltage of your mains electricity supply corresponds to the value V indicated on the appliance and that the socket and power line are appropriately dimensioned. Clean the air intake and output grills with a vacuum cleaner, then replug into the mains and turn on again. MAINTENANCE Before carrying out any operation on the radiator, unplug from the electric mains and wait for it to cool. the oil-filled electric radiator requires no particular maintenance. It is sufficient to remove the dust with a soft, dry cloth. never use abrasive powders or solvents. If necessary remove concentrations of dirt using a vacuum cleaner. IMPORTANT WARNING: In order to avoid overheating, never under any circumstances cover the appliances during operation, as this would lead to dangerous overheating. If this recommendation is not respected, a safety device will turn the radiator off. to reset , contact the technical assistance service. - Never use the radiator near a bath, shower, basin or swimming pool. [. . . ] to reset , contact the technical assistance service. - Never use the radiator near a bath, shower, basin or swimming pool. - Never use the radiator to dry damp garments. - If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. [. . . ]