User manual DELONGHI LM 190

[. . . ] Keep it away from the reach of children and persons unfit to use it. Do not run the appliance over the power cord as this may damage the insulation. Do not use to pick up flammable liquids. Do not use the appliance to pick up matches, hot ash, or burning cigarette ends. [. . . ] 3). b) Attach the accessory holder (30) by pressing it firmly onto to the trolley (if supplied) (Fig. 4) c) Check that the polyurethane foam filter (31), required for both wet vacuuming and extraction cleaning, is fitted into the motor protection housing (Fig. 6) ­ capacity around 3. 0 litres ­ and fill it with shampoo and water, according to the following proportions: 200 ml of shampoo 2800 ml of water e) Re-attach motor unit to the tank, making sure to line it up with the notch over the suction inlet port (fig. 7). - lower the handgrip over the surface being cleaned, while at the same time pressing the spray trigger (Fig. place the wash-dry nozzle on the surface being cleaned; release the spray trigger and return the handgrip to the starting position (Fig. 11B) continue vacuum-only operation, with the spray trigger released, moving the washdry nozzle over the cleaned surface. - - f) Insert the flexible hose into the suction inlet by turning the coupling (bayonet fitting) clockwise and insert the solution hose into the corresponding inlet, located above the suction inlet (Fig. g) Attach solution dispenser to the flexible hose using the plastic clips. 5 During this operation, the dirty water vacuumed up by the appliance can be seen inside the transparent wash-dry nozzle. If the water inside the nozzle is clean, the surface too is perfectly clean. When no more water is vacuumed up, the surface is almost dry and the operation is complete. Always use the original no-foam shampoo. If the fabric has previously been treated with a shampoo other than the product suggested for extraction cleaning, excessive foam may form inside the dirty-water tank. If foam is released from the top of the applian- 04/07 GB 28-09-2001 9:57 Pagina 6 ce, turn it off immediately and empty the tank (see "Care and maintenance"). When the dirty-water tank is full, a ball cock will shut suction off automatically and speed of the motor will increase (Fig. At this point, empty the dirty-water tank (see "Care and Maintenance". onto the handgrip or on the extension tubes. Plug the appliance in and switch it on by pressing the ON/OFF switch. Thanks to the wide range of attachments available, your cleaner will effectively vacuum up: - dust from carpets, matting, rugs, and hard floors. use the carpet/floor brush (29) - dust, crumbs, small debris from radiators, drawers, cobwebs from corners: use the crevice tool (28). - oil, saw dust, wood shavings, etc, from all types of floors, car interiors, garages, cellars: use either the suction hose or the multi-purpose nozzle (24) which can also be used to pick up dust, crumbs, fluff, etc. Caution: never press the pump button when the cleaner is being used for wet or dry vacuuming. Upon completion of the operations, empty the water tank (see "Care and maintenance"). Extraction cleaning: Cleaning hard floors (ceramic tiles, fired clay tiles, marble, linoleum, vinyl, etc. ) Fit the transparent wet-dry nozzle (22) by inserting it from left to right (Fig. 13) and proceed as indicated in the operating instructions. Wet vacuuming Caution: check that the appliance is not plugged in to the power outlet. This function will help you to cope with those little emergencies, such as: - unclogging a drain or a blocked sinks, minor floods (washing machines, dishwashers), spilt liquids, defrosting refrigerators and freezers, etc. [. . . ] This appliance is guaranteed against faulty manufacture and defective parts for a year from date of purchase. ELECTRICAL CONNECTION (U. K. ONLY) A) If your appliance comes fitted with a plug, it will incorporate a 13 Amp fuse. If it does not fit your socket, the plug should be cut off from the mains lead, and an appropriate plug fitted, as below. WARNING: Very carefully dispose of the cut off plug after removing the fuse: do not insert in a 13 Amp socket elsewhere in the house as this could cause a shock hazard. [. . . ]