User manual DELONGHI PACC 110

[. . . ] Warnings · This appliance is designed for home air conditioning and must not be used for other purposes. · It is dangerous to modify or alter the characteristics of the appliance in any way. · The appliance must be installed in conformity with national legislation regulating electrical equipment and installations. · If the appliance requires repair, contact a Service Centre authorised by the manufacturer only. [. . . ] How to programme delayed start up · Plug the appliance into a mains socket and press the ON/STAND-BY button (A), then select the required operating mode and other settings (temperature, fan speed, etc). · Press the ON/STAND-BY button (A) again: The appliance switches to stand-by mode (the two central segments are displayed). The last timer setting or the preset value 6. 0 flashes on the display. · Use the + (E) or - (F) buttons to set the number of hours delay before the appliance comes on. During the first ten hours, you can select half hour intervals. For times greater than ten hours, one hour intervals can be selected. If the + (E) or - (F) buttons are pressed for more than 2 seconds, the time runs rapidly up to a maximum of 24 hours. Press the timer button again within a few seconds to confirm the setting. If the setting is not confirmed within a few seconds, the display resets to stand-by. With the timer activated, the countdown before the programmed start up time is displayed and the light (H) flashes. To cancel the timer programme, press the timer button (D) again. How to programme delayed shutdown · Delayed shutdown can be programmed in any operating mode (air conditioning/dehumidifying/fan). The last timer setting or the preset value 6. 0 flashes on the display. · Use the + (E) or - (F) button to set the number of hours delay before the appliance goes off. During the first ten hours, you can select half hour intervals. For times greater than ten hours, one hour intervals can be selected. If the + (E) or - (F) buttons are pressed for more than 2 seconds, the time runs rapidly up to a maximum of 24 hours. Press the timer button again within a few seconds to confirm the setting. When the timer is set, the light (H) flashes. At the set time, the air conditioner shuts down and remains in stand-by. To cancel the timer programme, press the timer button (D) again. 25 GB Self-diagnosis SELF-DIAGNOSIS The appliance has a self diagnosis system to identify a number of malfunctions. IF . . . IS DISPLAYED . . . WHAT SHOULD YOU DO? When the appliance is operating in dehumidifying mode, this device prevents the formation of ice. [. . . ] To clean the filters, proceed as follows 1. Remove the dust filter by extracting it upwards (figures G and H). Use a vacuum cleaner to remove dust accumulations from the filter. If it is very dirty, immerse in warm water and rinse a number of times. [. . . ]