User manual DELONGHI PACFX 160

[. . . ] GB 19-06-2003 9:09 Pagina 4 Important Safe-guards · This appliance has been manufactured to cool and de-humidify domestic environments and should not be used for other purposes. · It is dangerous to alter or modify the unit's characteristics in any way. · The appliance must be installed in conformity with the relevant national legislation. · Should repairs be necessary, contact the nearest authorised Repair Service Centre. [. . . ] Function Button Air-conditioning, dehumidifying, ventilation C. Increase temperature button / increase operating time button G. Decrease temperature button / Decrease operating time button H. Display Displays the temperature selected, time programmed I. Fan speed button ELECTRICAL CONNECTION Before plugging in check that: · the mains supply corresponds to the value shown in the specifications table; · the socket and the mains lead correspond to the power requirements of the appliance; · the socket is suited to the plug, otherwise have the socket replaced; · the socket is properly grounded. The manufactures cannot be held responsible for any damages due to failure in following normal safety procedures. Replacement of the power cable must be carried out by qualified personnel. 9 GB 19-06-2003 9:09 Pagina 10 Operation SWITCHING THE APPLIANCE ON Connect the appliance to the mains supply. On the display two lines will appear indicating Stand-by mode Press the ON/OFF button (A) and then the MODE button until the relevant function indicator appears viz. : Indicator C Indicator D Indicator E : air-conditioning : dehumidifying : purification/ventilation AIR-CONDITIONING FUNCTION This function is ideal in hot, humid weather conditions when the atmosphere requires to be cooled and dehumidified. To ensure proper function of the appliance, after selecting the air-conditioning function, press buttons + (F) or ­ (G) until the desired temperature appears on the display. The temperatures most suited to the atmosphere in summer vary between 24 and 27°C (75 and 80°F). We do not advise selection of temperatures much lower than those outside. Select fan speed by pressing the "FAN" button (Q) until the fan speed indicator appears: MAX (P): if you want the maximum power of the air-conditioner to reach the desired temperature as quickly as possible. MIN (O): if you want to reduce the level of noise and still maintain a good level of comfort. SILENT (N): when minimum noise is required, AUTO (M):if you prefer the appliance to select the fan speed for the temperature selected on the display panel. 25 DEHUMIDIFYING FUNCTION This function is ideal for reducing humidity in the atmosphere while avoiding increases or decreases in temperature (in between seasons, damp places, wet spells of weather). When you select the dehumidifying function, the letters " " will appear on the display. The water is collected in the tank at the rear of the appliance. When the tank is full, the appliance will stop working and the display will show the letters " " (Full Tank); the tank must then be emptied. When it is re-inserted, the appliance will re-start automatically. remove the air exhaust hose (13). 10 GB 19-06-2003 9:09 Pagina 11 Operation VENTILATION/PURIFICATION This is ideal for dusty or polluted areas; in effect, the appliance recycles and purifies the air using the dust filters and 3M FiltreteTM electrostatic filters fitted. Adjust the fan speed by pressing the "FAN" (Q) button, as illustrated in the air conditioning function. Bear in mind that the higher the speed, the greater the volume of air filtered; by selecting the "Silent" speed, less air is filtered, but the noise level is low. "AUTO" function cannot be selected in this mode. The display will show the fan speed selected. [. . . ] If very dirty, immerse in warm water (not more than 40° C) and rinse thoroughly. To replace, fit the filters to the intake grill and attach to the appliance. Do not try to clean the 3M filter as this could result in a reduction of filter capacity. BEGIN OF SEASON CHECKS Check that the power cord and plug are undamaged and that the appliance is properly earthed. The installation instructions should be observed meticulously. [. . . ]