User manual DELONGHI PACL 20H

[. . . ] Warnings ENGLISH · · · · · · · · · · · · · · · · · · · · · · · · · · This appliance is designed for home air conditioning and must not be used for other purposes. It is dangerous to modify or alter the characteristics of the appliance in any way. The appliance must be installed in conformity with legislation in force in the country concerned. If the appliance requires repair, contact a Service Centre authorised by the manufacturer only. [. . . ] Then select the fan speed by pressing the FAN button (P) until the indicator light corresponding to the required fan speed lights up MAX: the air conditioning unit operates at maximum to reach the required temperature as rapidly as possible MIN: reduces noise levels but still maintains a good level of comfort QUIET: for silent operation AUTO: the appliance automatically selects the most suitable fan speed in relation to the temperature set on the digital display. The most suitable temperature for the room during the summer varies from 24 to 27°C. You are recommended, however, not to set a temperature much below the outside temperature. 25 24 L10/ L15/ L20H operation FAN MODE HEATING MODE (MODEL L20H ONLY) To set operation of the appliance correctly, press the "+" (F) or "-" (I) buttons until the desired temperature is displayed. In heating mode, the fan speed is selected automatically by the appliance. The "AUTO" light (O) on the control panel comes on. SETTING THE TIMER The timer can be used to delay appliance start up or shut down. This avoids wasting electricity by optimising operating periods How to programme delayed start up · Plug the appliance into a mains socket and press the ON/OFF (A) button, then select the required operating mode and other settings (temperature, fan speed, etc). · Press the ON/OFF (A) button again to place the appliance in standby mode. The two centre segments flash on the display. · Use the "+" (F) o "-" (I) buttons to set the number of hours delay before the appliance comes on. The setting is increased or decreased by an hour at a time; however, when the buttons are held down for more than two seconds, the time runs rapidly up to a maximum of 24 hours. Wait a few seconds for the data to be acquired. The indicator light (G) flashes until the appliance starts up. You can set the appliance to come on with a delay of up to 24 hours. To cancel the timer setting, press the timer button (Q), and use the "-" button (I) to set the time to zero. The indicator light (G) will stop flashing. How to programme delayed shut down · Delayed shut down can be programmed in any operating mode (air conditioning / fan / heating) (model L20H only). The two centre segments flash on the display. · Use the "+" (F) o "-" (I) button to set the number of hours delay before the appliance goes off. The setting is increased or decreased by an hour at a time; however, when the buttons are held down for more than two seconds, the time runs rapidly up to a maximum of 24 hours. Wait a few seconds for the data to be acquired. The indicator light (G) flashes until the appliance shuts down. To cancel the timer setting, press the timer button (Q), and use the "-" button (I) to set the time to zero. [. . . ] CLEANING THE CABINET You should clean the appliance with a slightly damp cloth then dry with a dry cloth. For safety reasons, never wash the air conditioning unit with water. Precautions Never use petrol, alcohol or solvents to clean the appliance. Never spray insecticide liquids or similar. [. . . ]