User manual DELONGHI PENTAVAP EL. W F

[. . . ] Delivery lever Delivery tube connection Motor unit Water or water + shampoo selector knob connection Water or water + shampoo selector knob External tank Clips Liquid level indicators Liquid collection drum Handgrip Manual suction power regulator Motor unit handle Electronic suction power regulator (electronic version only) Delivery tube connection Motor housing Delivery tube Hose coupling Vacuum on light Vacuum button "Cleaning off" button Cold water cleaning button Hot water cleaning button Steam cleaning button "Cleaning on" light Tools 25. Hard floor attachment Important information for correct disposal of the product in accordance with EC Directive 2002/96/EC. At the end of its working life, the product must not be disposed of as urban waste. It must be taken to a special local authority differentiated waste collection centre or to a dealer providing this service. [. . . ] Connect the hose to the suction port of the appliance by rotating the hose coupling (17) clockwise until firmly attached (fig. Connect the delivery tube to the drum, pushing it in until the release/lock button clicks. Connect the extension tubes (26) to the handgrip (10) then fit the tool most suitable for the cleaning to be performed to the other end. Crevice tool (33) Use to collect crumbs, dust and small debris. Perfect for hard-to-reach corners, such as between radiators, car interiors, etc. I) Multipurpose nozzle (31) Use to clean sofas, upholstery, car interiors, curtains, etc. Brush tool (32) Use to remove dust from upholstery, furniture, books, curtains, picture frames and clothes (fig. WET VACUUMING This function of the PENTAVAP enables the appliance to be used to tackle those minor household emergencies requiring liquids to be collected, such as blocked sinks or drains, small floods (washing machine, dishwasher, cellars etc. ), without immersing the appliance in the water. Set the appliance up as described in point 1 (dry vacuum function). Crevice tool (32) Use to vacuum up liquids from hard-to-reach points and blocked sinks. Small triangular nozzle (40) Use the small triangular nozzle to wash and wet vacuum upholstery, sofas, furniture and hanging fabrics. Connect the delivery tube to the hose handgrip and push as far as it will go until the release/lock button clicks (fig. Large triangular nozzle (47) Useful for picking up liquids from floors, carpets and rugs. When using on hard floors, fit the hardfloor attachment (48). WET VACUUMING TOOLS In the event of difficulty, first empty the diffuser cone. Remove the steel handle before extracting (fig. EXTRACTION CLEANING The appliance uses cold water to protect floors and fabrics while cleaning, hot water to remove tougher dirt and steam for perfect hygiene on all types of surface. IMPORTANT: make sure the fabrics and surfaces to be cleaned are suitable for and resistant to extraction cleaning. If in doubt, try on a corner of the rug or surface to be cleaned and wait until completely dry to verify the result. NB: if the fabric surface being cleaned has been previously washed using shampoo other than the type supplied, this may cause excessive foam to form inside the drum. If foam leaks from the head, switch the appliance off immediately and empty the drum. Always use the original low-foam shampoo. Set the appliance up as described in point 1 (dry vacuum function). Plug the appliance into the mains socket and turn on using the vacuum button (fig. IMPORTANT: the appliance can hold around 8 litres of water in the liquid collection drum. [. . . ] Check regularly that the float in the motor housing (15) is free to move by raising the head of the appliance and shaking it. To store the appliance, place the tools inside the drum. The extension tubes can be stored between the external tank and the drum. Wind up the cable (making sure it is undamaged and not worn or rubbed) in the special space around the motor head and Z5 fasten in place with the clip (fig. [. . . ]