User manual DELONGHI PLS120

[. . . ] 00 Dear Customer, Thank you for having chosen a , air conditioner, which is an innovative, high quality product designed to ensure your wellbeing. This instruction booklet contains important information and recommendations that we would ask you to comply with to obtain best results from your air conditioner. De’Longhi Group In line with the company’s policy of continual product improvement, the aesthetic and dimensional characteristics, technical data and accessories of this appliance may be changed without notice. 18 GENERAL INFORMATION CONFORMITY AND RANGE The air conditioner you have purchased is in conformity with the following European Directives: • Low Voltage 73/23/EEC • Electromagnetic compatibility 89/336/EEC GENERAL INFORMATION SINGLE SPLIT ENGLISH 1 SAFETY RULES AND RECOMMENDATIONS GENERAL INFORMATION Read this guide before installing and using the appliance. [. . . ] Each time the buttons are pressed the set temperature value increases or decreases by 1°C. The appliance is fitted with a Hot Start function, which delays appliance start-up for a few seconds to ensure an immediate output of hot air. USER 12:38 AM MODE OFF TIMER INTELLIGENT REMOTE CONTROL RESET + ON OFF 88 USER 12:38 AM MODE OFF TIMER SMART MODE Automatic mode To activate the SMART function, press the ( ) button on the remote control. The writing AU (AUTO) will appear on the display. mODE USER INTELLIGENT REMOTE CONTROL RESET + ON OFF !88 FAN MODE Fan mode Press the MODE button until the FAN ( USER ) symbol appears. MODE INTELLIGENT REMOTE CONTROL Every time the FAN button is pressed the speed changes in the following sequence: AUTO – LOW – MEDIUM – HIGH. The remote control also stores the speed that was set in the previous mode of operation. OFF TIMER 88 SINGLE SPLIT ENGLISH 9 SLEEP MODE Night mode To activate the night function in the COOL, DRY and HEAT modes, press the SLEEP ( ) button. To deactivate the night function, press the SLEEP ( ) button again. During operation in the night mode, the set temperature increases by 1 °C in the first hour of operation and by another 1 °C in the following hour, maintaining this increase of 2°C in the subsequent hours. Selecting the night function in the heating mode, the set temperature decreases by 1 °C in the first hour of operation and by another 1 °C in the following hour, maintaining this decrease of 2°C in the subsequent hours with the fan operating at minimum speed. rESET USER INTELLIGENT REMOTE CONTROL ON OFF !MODE 88 USER RESET INTELLIGENT REMOTE CONTROL TURBO POWER FUNCTION To activate the TURBO POWER function, press the , appears on the display. The symbol In the COOL or HEAT mode, the air conditioner will automatically operate at maximum power. To deactivate this function just change the fan speed or press the button again. This function is used to obtain the required climate in the exact point where the remote control is located. The temperature of reference is that measured by the sensor in the remote control, bypassing the temperature sensor inside the air conditioner. The remote control must always by pointed at the unit. If no signal is received from the remote control for 11 minutes, the unit will once again refer to its own internal sensor. MODE 88 USER RESET INTELLIGENT REMOTE CONTROL LIGHT FUNCTION Press the LIGHT ( ), button and the symbol appears on the display. Upon activating this function the LEDs on the indoor unit display go out while air conditioner operation remains unchanged. [. . . ] Before carrying out any maintenance, disconnect from the power supply by putting the installation on/ off switch to “off”. Installing the filter • Keeping the front panel raised with one hand, insert the air filter with the other hand (see fig. ) • Insert the air filter • Let the front panel slide downwards and ensure that the three catches (A, B and C) are properly inserted • Close B INSTALLATION 1 2 C A Note: the above figures may not correspond to the appearance of the units that have been purchased. The antibacterial silver ion filter and the biological deodoriser electrostatic filter (if installed) cannot be washed or regenerated. [. . . ]