User manual DELONGHI PRIMA DONNA CLASSICO

[. . . ] Failure to do this will present a danger of overheating. PLACING THE PEBBLES/ COAL Depending on which stove you have purchased you will find pebbles or coal packed with your stove. In order to place the pebbles/coal on the shelf within the stove you will need to remove the silver front panel. The front panel is held in place by two magnets at the top and by two pegs at the bottom. [. . . ] Pressing this switch down, turns the light pattern on with no heat, so that you may enjoy the flame effect all year round. When this switch is pressed up, the light pattern is off. Heat Levels For minimum heat, press the switch marked with one bar (1kW). For maximum heat, press both the switch marked with one bar and the switch marked with two bars (2kW). Automatic Safety Cut Out This heater is fitted with an automatic cut out to prevent any damage due to overheating. The heater will automatically cut out if the airflow is obstructed. To reset the stove, disconnect the plug from the power socket for a few minutes, remove the cause of obstruction and allow a suitable cooling period before plugging it in again. Noise As with all fan driven appliances the stove will make some noise due to the movements of air occurring, this is perfectly normal. MAINTENANCE Before any maintenance/cleaning is undertaken always disconnect the stove from the power supply. Replacing light bulbs The Prima Donna comes fitted with two 60W daylight (craftlight) bayonet cap bulbs. The Prima Donna Classico comes fitted with two 40W red bayonet cap bulbs. Replacements are available from good hardware/large DIY stores. To change the bulbs you will need to remove the silver front panel, but first, allow a suitable time for the bulbs to cool. 3 The bulbs can easily be changed as follows: 1. Firmly hold both sides of the silver front panel 2. Carefully pull the top of the panel towards you, away from the magnets 3. Slide the panel upwards until the pegs come out of their holes 4. Now the bulbs can be changed (use bulbs as described above). Replace the panel by relocating and sliding the pegs back into their holes and pushing the top of the panel to reconnect with the magnets. Please note that replacement bulbs are not covered by the guarantee of the product. Cleaning The fire can be cleaned with a soft damp cloth. Do not use metal polish or harsh scouring agents. WARNINGS · Do not use the stove in a bathroom or in the vicinity of bathtubs, washbasins, showers or swimming pools. · Do not use the heater to dry your laundry. Never obstruct the intake and outlet grilles (danger of overheating). [. . . ] If it does not fit your socket, the plug should be cut off from the mains lead and an appropriate one fitted as below. WARNING: Very carefully dispose of the cut off plug after removing the fuse: do not insert in a 13 amp socket elsewhere in the house as this could cause a shock hazard. With alternative plugs not incorporating a fuse the circuit must be protected by a 15 amp fuse. If the plug is a moulded-on type, the fuse cover must be refitted when changing the fuse using a 13amp Astra approved fuse to BS1362. [. . . ]