User manual DELONGHI TCH 7091ER

[. . . ] If your appliance is not fitted with a plug, please follow the instructions provided below: B) IMPORTANT The wires in the mains lead are coloured in accordance with the following code: Blue: Brown: Neutral Live As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which si marked with the letter L or coloured red. 2 Fig. 1 H D E B D E F A B C F G A C I J 3 GB DESCRIPTION A ON/STAND-BY button B +/- Adjustment buttons C Oscillation button D "ECO" function button E Timer button F MODE button (for selecting the operating mode) G Receiver for remote control H Power indicator light I Back cover J Filter ELECTRICAL CONNECTION - Before connecting the plug to the power outlet, make sure that the voltage of your electrical system corresponds to the voltage shown on the appliance rating label and the outlet you are going to use is in good condition. - THIS APPLIANCE COMPLIES WITH DIRECTIVE 2004/108/EEC ON RADIO INTERFERENCE SUPPRESSION. [. . . ] The display shows the symbol and the time remaining before switch-on. To set the timer, use the + and - adjustment buttons (B), then wait a few seconds for the programming to be set. The display returns to show "G" for stand-by and the symbol to indicate you have set the timer. When the programmed time has been reached, the appliance turns on with the same settings it had during the previous operation. Delayed shut-off: With the appliance on, press the timer button (E) ( ). The display shows the symbol and the time remaining before shut-off. To set the timer, use the + and - adjustment buttons (B), then wait a few seconds for the programming to be set. The display returns to show the current settings and the symbol to indicate you have set the timer. When the programmed time as been reached the appliance shuts off automatically. If you want to go back to operation without the timer, press the timer button (F) twice. The timer symbol disappears from the display. USING THE REMOTE CONTROL The remote control functions correspond to those on the control panel. See the section "Operation and Use" on the previous page for a description of the functions. Inserting or replacing the batteries - The remote battery control is provicover ded with a battery lithium battery CR2032. To let the appliance function, remove the battery Fig. - To replace the batteries, remove the battery cover by rotating it. Replace the battery paying attention to respect the right polarity as shown in figure 2. - Replace the cover rotating it towards the - position "CLOSE". Old batteries must be removed and disposed off in accordance with current legislation as they are harmful to the environment. MAINTENANCE - Before carrying out any maintenance, always unplug from the mains socket. - During the season when the appliance is in use, clean the air intake and outlet grilles regularly using a vacuum cleaner. [. . . ] obstruction of air intake and outlet grilles, motor turning slowly or not at all). To reset, unplug the appliance from the mains socket for a few minutes, remove the cause of overheating then plug in again. - Tip over safety switch: a safety tip-over switch turns the ceramic heater off if it tips over or is positioned in an improper way that could jeopardize safety. The appliance emits a beep and the display will show a blinking dot. [. . . ]