User manual DELONGHI VENEZIA

[. . . ] Proceed as follows: • Fix the brackets “D”, making sure the distances are as shown in fig. € Hang the heater on the two brackets fixed to the wall. Insert the two brackets “E” in the back of the convector base as shown in fig. Mark the bracket fixing points on the wall. [. . . ] € Remove the heater, drill the wall and insert the anchors. € Fix the heater again, inserting the brackets “E” into the base of the heater and fixing them to the holes in the wall using the screws. The appliance must not be positioned directly underneath a fixed power point. Position the appliance in such a way that the plug is easily accessible even after installation. Operation and use Turning on Plug into the mains, turn the thermostat dial (B) to maximum and turn the appliance on by means of the power selector (A) as described below. € Turn the selector to the Min position to select minimum power (the Min power light comes on). € Turn the selector to the Med position to select medium power (the Med power light comes on). € Turn the selector to the Max position to select maximum power (the Max power light comes on). Adjusting the thermostat When the room has reached the required temperature, turn the thermostat dial (B) slowly anticlockwise until the lights go out and no further. The thermostat will automatically regulate the temperature set and keep it constant. A little smoke due to the protective substances applied to the heating element before transport may be given off. € Do not use the convector heater near bath tubs, showers, sinks or swimming pools. The appliance must not be placed directly under a fixed socket. € Do not rest the power cable on the appliance when hot. • Always use the heater in a vertical position only. € Do not obstruct the hot air outlet grilles or the air intake grille on the bottom of the appliance. € If the power cable is damaged, it must be replaced by the manufacturer, an authorised service centre or a qualified electrician in order to eliminate all risk. € Do not use this appliance in rooms measuring less than 4m2. You should avoid positioning it in currents of air which could disturb operation of the heater. A safety device trips and turns the appliance off in the event of overheating or if it is placed in strong currents of air. [. . . ] To reset, unplug the appliance from the mains socket and leave to cool down (about five minutes), remove the cause of overheating, plug back into the mains and turn on again. A number of models are fitted with a special device which turns power off if the appliance is tipped over, sloped or knocked. Important: never under any circumstances cover the appliance during operation as this would lead to dangerous overheating of the appliance itself. iMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH EC DIRECTIVE 2002/96/EC. [. . . ]