User manual DELONGHI VVX 2200

[. . . ] GB Read this manual thoroughly before using the appliance. This will ensure optimum results and maximum safety. Save these instructions for future reference. mal expansion of the metal it is made from. [. . . ] Iron whites and light colours on the right side and dark colours on the reverse. Embroidery should also be ironed on the reverse to make it stand out. · Each time the iron is used (including for the first time) or if you have not used steam for several minutes, press the steam delivery button a number of times away from the ironing board. This will eliminate cold water from the steam circuit. · During use, the iron can be rested in a "vertical" position (see figure below). 0 - 9 °F 10 - 18 °F 19 - 36 °F > 37 °F Soft Medium Hard Very hard TURNING THE APPLIANCE ON FOR THE FIRST TIME · Plug the appliance into a mains socket (fig. 1) · The display (F) shows: français (see fig. · Turn the function selector knob (H) until the required language is displayed, then confirm by pressing the knob (fig. · The display shows: SET WATER HARDNESS (see fig. 4): select the water hardness (soft, medium, hard, very hard, see table) by turning the knob (H), then confirm by pressing the knob (fig. · The display shows: However, make sure the surface is even to avoid the iron falling over. · In models with domestic iron, the iron can be secured in position (see figure on page 15). Important: never move the appliance by the iron handle INSERT SCALE FILTER insert the filter and confirm by pressing the knob (fig. · For two seconds, the display shows: PREPARATIONS FOR USE The machine works with normal tap water. Never use other types of water, chemical substances or detergents (e. g. perfumed water, essences, water softener, etc). There is a water hardness indicator paper in the packaging. Immerse the indicator paper in the water for one second, shake it to remove excess water, wait about one minute, then use the result to set the appliance the first time you use it (see table). ok It then shows: FILL TANK fill the removable water tank (M), open the door (L) (fig. 7) and position the tank correctly (fig. · The display shows: WAIT FOR FIRST CYCLE the pump can be heard filling the system with water. 14 This first phase is necessary as the steam generator leaves the factory without water. When you turn the iron on subsequently and during operation, from time to time you will hear noise and vibrations from the pump as it tops up the level of water in the steam generator. This is part of normal operation and is not hazardous. · When the steam generator is full, the display shows: Wool Cotton Linen Jeans Vertical ironing (for freshening curtains and jackets) Steam is not available in the "Quick&Go", "Synthetics" and "Silk" programmes. · · · · · SYNTHETICS turn the knob (H) to select the programme corresponding to the fabric to be ironed (for example, jeans). [. . . ] Wait for the iron to reach the working temperature as explained on page 15. Wait for pressure in the control unit to reach the rated value. Select another programme. Steam is not delivered from the iron · · · · The iron is heating up. The ironing system is set to manual and regulated to low temperature (less than ). [. . . ]