User manual DELONGHI XVT 7000

[. . . ] GB 2-04-2002 8:01 Pagina 20 ENGLISH Dear Customer, Thank you and congratulations on your purchase of our appliance. All our products are the result of highly accurate planning and meticulous technical testing. We have prepared this manual to help you make the most of your deep-cleaner and to fully appreciate its superb quality. We are certain that, if you follow our suggestions, this appliance will give you maximum satisfaction and many years of service. [. . . ] Setting up the appliance for dry/wet vacuuming Open the front cover (1) by pulling trigger (10) placed under the handle of the appliance. Remove the water tank by pulling the trigger and at the same time lifting the tank by the handle (6). 1 2 By means of the hooks, remove the tank cover with float system. To extract the cover correctly, position the thumbs inside the central cavity in contact with the two projecting edges of the tank. Press on the two projecting edges to facilitate release of the cover tooth from the slot. Use the handle to facilitate extraction of the cover from the front lock. Press on the bottom of the front locking device to free the tooth from the slot. You can also act on the top of the hook to facilitate the operation. Remove the air flow conveyer (3) and pour water into the tank until the two projections on the base of the tank are covered (about 800 cc) Re-insert the air flow conveyer, to its original position. Replace the tank cover pressing down firmly to ensure the cover is locked in position. Hold down the trigger (10) and replace the tank to its final position. N. B. : No water is necessary if the appliance is going to be used for wet vacuuming. 23 GB 2-04-2002 8:01 Pagina 24 27 Fit the appliance with flexible hose (28). Insert bayonet coupling (27) into the hole on front cover (1), pressing it in firmly and rotating clockwise until it stops. Open safety hatch (14) and plug in connector (26) into socket (13) on the bottom of the machine, making sure the reference arrow is pointing upward. Push in firmly until securely locked in place. 26 To disconnect, push on the two side locking tabs and pull. A Insert extension tube (29) onto the flexible hose handgrip making sure the handgrip coupling is perfectly connected with the extension tube coupling. Push firmly all the way in, then lock into position by rotating the locking ring (A). Try to pull the extension tube out to make sure the connection is perfectly secure. To add the second extension tube or the brush nozzle, proceed as described above. Connect the power cord to the mains, press on/off button (15) and indicator light (17) will come on. Now your appliance is ready to start. 24 GB 2-04-2002 8:01 Pagina 25 To activate vacuuming, press Suction button ON/OFF (23) on the handgrip of the flexible hose. The appliance will be reach maximum vacuuming power in a few seconds. To disactivate suction, press Suction button ON/OFF (23) once more. To decrease or increase suction power, press button (24) keeping it depressed until the desired suction power has been reached. N. B. : Do not press button (16) to power the boiler when the appliance is used for vacuuming only. Important notice: during wet vacuuming, when tank (2) is full, a special device will shut suction off and the motor will rev up. At this point, switch off the appliance by pressing button (15), disconnect it from the mains, and empty out the wet/dry tank. [. . . ] "T" nozzle with brush-tipped steam insert (48) Fit directly onto the extension tube or the handgrip making sure the coupling is perfectly connected with the extension tube or the handgrip coupling. Push firmly all the way in, then lock into position by rotating the locking ring. Tile grouting, radiators, bathroom fixtures and all other nooks and crannies will be easily dealt with by using the crevice tool together with the bush-tipped steam insert. To vacuum and dry the surface more effectively, remove the brush. [. . . ]