User manual DELONGHI XW 1400CA

[. . . ] For machines with double insulation (see the symbol on the specifications label), earthing is not necessary. · Always disconnect the appliance from mains outlet when not in use or before any maintenance or care operation. · Do not clean the appliance with benzine or other solvents. · Do not tug on the power cord, or the machine itself, to disconnect the appliance from mains outlet. [. . . ] Ideal for vacuuming liquids, the brush has a removable frame with a rubber section to facilitate wet vacuuming. To replace the removable frame, press the two small levers on the sides of the frame downwards. Preparing for use Remove the motor unit by pulling the catches outwards to release. Lift off motor unit by the easy-grip handle, remove tools out of the tank (Fig. Turn the appliance over and fit with the wheels provided, pushing them into the slots on the base of the tank (Fig. 3). Vacuuming liquids: Make sure that the polyurethane foam filter required for extraction cleaning and wet vacuuming is fitted over the motor housing (fig. Dry vacuum function: Make sure that the motor-protection paper bag is fitted over the motor housing. Secure the filter with the special elastic ring (where provided) or an ordinary elastic band (fig. 5). Position the dustbag inside the tank by fitting the cardboard collar onto the suction inlet port and pressing firmly in place (fig. 6). 9 Dry vacuum function Make sure that the motor-protection paper bag (13) or cloth bag (where provided) is fitted over the motor housing. Secure the filter with the special elastic ring (where provided) or an ordinary elastic band (fig. 6). ENGLISH Descrizione Fit the telescopic tube K onto the hose grip, pushing it fully into place. xp GB 8/11 26-11-2002 11:20 Pagina 10 "Explora" carpet/floor brush: Cleans dust efficiently from both hard floors or mats and carpet. Thanks to the articulated fins, this model is particularly suited to cleaning right up close to furniture and into corners. Cleaning and maintaining the appliance CAUTION: before starting cleaning or maintenance operations, ensure that the appliance is unplugged from the mains. Once you have finished using the appliance as a wet vacuum cleaner you are advised to rinse the attachments by sucking in a few litres of clean water. This will clean the attachments and the inside of the hose. Remember to empty the dirty water collection tank after every cleaning operation. o (fig. After emptying and rising the tank, the polyurethane motor filter must be removed, washed under running water and dried. The filter must be kept dry to prevent deterioration. For cleaning wider areas, simply rotate the brush to use the total width. Accessory for delicate floors of the "Explora" brush (some models only) The accessory features felt strips for using the brush on delicate surfaces such as parquetry and treated marble. To fit the accessory to the base of the "EXPLORA" brush, line up the two pins on the accessory with the two holes on the bottom of the brush and press until it clicks into place. Crevice tool Ideal for collecting crumbs, dust and small deposits and in all hard-to-get-to places. Multi-function nozzle Used for cleaning sofas, upholstery, car interiors, drapes, etc. When cleaning drapes, if required, decrease the suction power by sliding the control on the handgrip of the appliance, so that the hole is fully or partially open. Maintenance of the paper or cloth filters To use the appliance as a dry vacuum cleaner, the motor protection bag must be replaced periodically. The cloth filter (if provided) can be washed periodically with water and soap; remember to dry it before re-using. [. . . ] With alternative plugs not incorporating a fuse, the circuit must be protected by a 15 Amp fuse. If the plug is a moulded-on type, the fuse cover must be re-fitted when changing the fuse using a 13 Amp Asta approved fuse to BS 1362. In the event of losing the fuse cover, the plug must NOT be used until a replacement fuse cover can be obtained from your nearest electrical dealer. The colour of the correct replacement fuse cover is that as marked on the base of the plug. [. . . ]