User manual DENON ASF-S05

[. . . ] Allow for sufficient heat dispersion when installed in a rack. [. . . ] The speaker stand's post has three speaker mount holes allowing the height of the speaker to be adjusted in three steps. Be careful not to damage the post or speaker with the hex wrench when tightening the screws. Be sure to check for safety directly after installing, then conduct safety checks periodically to be sure there is no risk of falling or tipping. DENON will accept no responsibility whatsoever for any damage or accidents due to inadequacies in the place or method of installation. 5 kg/stand b For purposes of improvement, specifications and design are subject to change without notice. B Attach the spacers evenly above and below the screw section to prevent the speaker and speaker stand from touching each other. B After mounting the speaker, pull the speaker cable the necessary amount so that there is no slack inside the post. When assembling, be very careful not to injury yourself by letting the speaker stand tip over accidentally or dropping the speaker. [. . . ] When moving the speaker stand, disconnect the speaker cables from the receiver, etc. [. . . ]