User manual DENON AVC-A1SRA

[. . . ] The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. We declare under our sole responsibility that this product, to which this declaration relates, is in conformity with the following standards: EN60065, EN55013, EN55020, EN61000-3-2 and EN61000-3-3. Allow for sufficient heat dispersion when installed on a rack. Se till att det finns möjlighet till god värmeavledning vid montering i ett rack. [. . . ] When this is done, signals encoded in the Dolby Headphone mode are automatically output from the recording output terminals (analog and digital) and can be recorded. NOTE: Do not disconnect the headphones during recording. The play mode switches as shown below each time the button is pressed. -R (surround right), SB-L (surround back left) and SB-R (surround back right) channels of the EXT. IN jacks are output directly to the front (left and right), center surround (left and right) and surround back (left and right) speaker systems as well as the pre-out jacks without passing through the surround circuitry. Select the parameter (jog stick up/down) and select the setting value (jog stick left/right). Select the source you want to record appears on the set's display. When the AVC-A1SR is in the RECOUT mode, the source cannot be output using the MZONE2 buttons on the remote control unit. Input CH parameter 2 CH: Select when the input source being played is a 2-channel source. MULTI CH: Select when the input source being played is a multi-channel source. The signals of the source selected in the MZONE2 mode are also output from the TAPE and VCR recording output terminals. Digital signals are not output from the MULTI ZONE1 audio output jacks. IN (1 or 2), playback in the DIRECT, STEREO, DOLBY/DTS SURROUND, HOME THX CINEMA, WIDE SCREEN, 5CH/7CH STEREO and DSP SIMULATION modes is only possible when DSP MODE is selected for Ext. When the "INPUT CH" parameter is set to "MULTI CH", the "MULTI CH DIRECT" mode is set when the DIRECT button is pressed, and the "MULTI CH IN" mode is set when the DOLBY DTS/SURROUND button is pressed. In play modes other than the external input mode, the signals connected to these jacks cannot be played. In addition, signals cannot be output from channels not connected to the input jacks. The external input mode can be set for any input source. To watch video while listening to sound, select the input source to which the video signal is connected, then set this mode. 2 Playback using the DENON Link connector Digital transfer and multi-channel playback of DVD audio discs and other multi-channel sources is possible by connecting the AVC-A1SR to a Denon DVD player equipped with a Denon Link connector using the connection cable included with the DVD player. With discs on which special copyright protection measures have been taken, however, the digital signals may not be output from the DVD player. The system setup function cannot be used when the PURE DIRECT mode is set or the "VIDEO OFF" setting is selected. The channel level and surround parameters in the PURE DIRECT mode are the same as in the DIRECT mode. [. . . ] 1-channel, and the new "surround back (SB) channel" was added to achieve improvements over the conventional 5. 1-channel system in terms of the positioning of the sound at the rear, the acoustic image of sound moving from the two sides to the back as well as sound moving from the front to the center rear with the multi surround speaker systems used in movie theaters, thereby enabling various types of surround sound. The surround back channel signal is a matrix-encoded signal inserted into both the Dolby Digital SL (surround left) and SR (surround right) channels. Upon playback, the signals are decoded by a high precision digital matrix decoder within the Dolby Digital decoder into the SL, SR and SB channels and output as 6. [. . . ]