User manual DENON AVR-1604,MV

[. . . ] AV SURROUND RECEIVER RÉCEPTEUR AUDIO-VIDÉO AVR-1604/684 OPERATING INSTRUCTIONS MODE D’EMPLOI FOR ENGLISH READERS PAGE 2 ~ PAGE 62, 122 ~ 126 POUR LES LECTEURS FRANCAIS PAGE 2, 63 ~ PAGE 126 2 We greatly appreciate your purchase of this unit. Be sure to keep this manual for future reference should any questions or problems arise. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. [. . . ] Note that noise may be generated when using this mode to play signals other than PCM signals. E DTS (exclusive DTS signal playback mode) Decoding and playback are only performed when DTS signals are being input. R ANALOG (exclusive analog audio signal playback mode) The signals input to the analog input jacks are decoded and played. IN (external decoder input jack selection mode) The signals being input to the external decoder input jacks are played without passing through the surround circuitry. NOTE: • Note that noise will be output when CDs or LDs recorded in DTS format are played in the “PCM” (exclusive PCM signal playback) or “ANALOG” (exclusive analog audio signal playback) mode. Select the AUTO or DTS (exclusive DTS signal playback) mode when playing signals recorded in DTS from a laser disc player. Notes on playing a source encoded with DTS • Noise may be generated at the beginning of playback and while searching during DTS playback in the AUTO mode. € In some rare cases the noise may be generated when you preform the operation to stop playback of a DTS-CD or DTS-LD. (Main unit) (Remote control unit) 33 ENGLISH Input mode display • In the AUTO mode AUTO INPUT PCM DTS 3 Select the play mode. Press the SURROUND MODE button, then turn the SELECT knob. Example: Stereo One of these lights, depending on the input signal. (Main unit) DIGITAL • In the ANALOG mode AUTO INPUT PCM DTS ANALOG 4 5 Start playback on the selected component. Input signal display • DOLBY DIGITAL SIGNAL DIGITAL • DTS SIGNAL DIGITAL The volume level is displayed on the master volume level display. € PCM SIGNAL (Main unit) (Remote control unit) DIGITAL The volume can be adjusted within the range of –70 to 0 to 18 dB, in steps of 1 dB. However, when the channel level is set as described on page 37, if the volume for any channel is set at +1 dB or greater, the volume cannot be adjusted up to 18 dB. (In this case the maximum volume is adjusted to “18 dB — (Maximum value of channel level)”. ) Input mode when playing DTS sources • Noise will be output if DTS-compatible CDs or LDs are played in the “ANALOG” or “PCM” mode. When playing DTS-compatible sources, be sure to connect the source component to the digital input jacks (OPTICAL/COAXIAL) and set the input mode to “DTS”. The DIGITAL indicator lights when digital signals are being input properly. If the DIGITAL indicator does not light, check whether the digital input component setup (page 25) and connections are correct and whether the component’s power is turned on. NOTE: • The DIGITAL indicator will light when playing CD-ROMs containing data other than audio signals, but no sound will be heard. After starting playback [1] Adjusting the sound quality (tone) 1 The tone switches as follows each time the TONE CONTROL button is pressed. [. . . ] Disconnect the power immediately and contact your store of purchase. symptom Cause • Power cord not plugged in securely. DISPLAY not lit and sound not produced when power switch set to on. Measures • Check the insertion of the power cord plug. [. . . ]