User manual DENON AVR-5308CI

[. . . ] Se till att det finns möjlighet till god värmeavledning vid montering i ett rack. Do not let foreign objects into the apparatus. Unplug the power cord when not using the apparatus for long periods of time. Do not let insecticides, benzene, and thinner come in contact with the apparatus. [. . . ] AUTO (auto mode): In this mode, the types of signals being input to the digital and analog input terminals for the selected input source are detected and the program in the AVR-5308CI's surround decoder is selected automatically upon playback. This mode can be selected for all input sources other than TUNER. The presence or absence of digital signals is detected, the signals input to the digital input terminals are identified and decoding and playback are performed automatically with the DTS, Dolby Digital or PCM (2 channel stereo) format. If no digital signal is being input, the analog input terminals are selected. Use this mode to play Dolby Digital signals. PCM (exclusive PCM signal playback mode): Decoding and playback are only performed when PCM signals are being input. Note that noise may be generated when using this mode to play signals other than PCM signals. DTS (exclusive DTS signal playback mode): Decoding and playback are only performed when DTS signals are being input. Use this switch to monitor a video source other than the audio source. The AVR-5308CI has an AUTO signal detection mode that automatically identifies the type of incoming audio signals, but is also equipped with a manual mode that can be switched according to the type of input audio signals. Input mode when playing DTS sources: Noise will be output if DTS-compatible CDs or LDs are played in the "ANALOG" or "PCM" mode. The control can be set in 8 steps from 0 to 7. This parameter is displayed during DOLBY DIGITAL playback. This parameter is displayed during DOLBY DIGITAL playback. If you do want the bass and treble to be adjusted, turn off the tone defeat mode. When the surround parameters are set using the buttons on the main unit, stop operating the buttons after completing the settings. The settings are automatically finalized and the normal display reappears after several seconds. When making parameter settings, the display will return to the regular condition several seconds after the last button was pressed and the setting will be completed. Decoding is performed with emphasis on separation performance to achieve the same atmosphere with 2-channel sources as with 6. This mode is effective for playing sources recorded in conventional surround formats as well, because the in-phase component is assigned mainly to the center channel (C) and the reversed phase component to the surround (SL, SR and SB channels). The front channel (FL and FR) signals bypass the decoder and are played directly so there is no loss of sound quality, and the effect of the surround signals output from the center (C) and surround (SL, SR and SB) channels add a natural sense of expansion to the sound field. 3): The center image parameter for adjusting the expansion of the center channel in the DTS NEO:6 MUSIC mode has been added. [. . . ] 1" playback channels as Dolby Digital (front left, front right, center, surround left and surround right) as well as the stereo 2-channel mode. The signals for the different channels are fully independent, eliminating the risk of deterioration of sound quality due to interference between signals, crosstalk, etc. DTS features a relatively higher bit rate as compared to Dolby Digital (1234 kbps for CDs and LDs, 1536 kbps for DVDs) so it operates with a relatively low compression rate. Because of this the amount of data is great, and when DTS playback is used in movie theaters, a separate CD-ROM synchronized with the film is played. [. . . ]