User manual DENON AVR-770SD

[. . . ] The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. We declare under our sole responsibility that this product, to which this declaration relates, is in conformity with the following standards: EN60065, EN55013, EN55020, EN61000-3-2 and EN610003-3. Allow for sufficient heat dispersion when installed on a rack. Se till att det finns möjlighet till god värmeavledning vid montering i ett rack. [. . . ] Select the function to which the component you want to play is connected. To perform this operation from the remote control unit, check that the mode selector switch is set to "AUDIO". (Cinema Equalizer): The Cinema EQ function gently decreases the level of the extreme high frequencies, compensating for overly-bright sounding motion picture soundtracks. Select this function if the sound from the front speakers is too bright. This function only works in the Dolby Pro Logic II, Dolby Digital and DTS Surround modes. (Dynamic Range Compression): Motion picture soundtracks have tremendous dynamic range (the contrast between very soft and very loud sounds). For listening late at night, or whenever the maximum sound level is lower than usual, the Dynamic Range Compression allows you to hear all of the sounds in the soundtrack (but with reduced dynamic range). (This only works when playing program sources recorded in Dolby Digital. LFE (Low Frequency Effect): This sets the level of the LFE (Low Frequency Effect) sounds included in the source when playing program sources recorded in Dolby Digital or DTS. If the sound produced from the subwoofer sounds distorted due to the LFE signals when playing Dolby Digital or DTS sources when the peak limiter is turned off with the subwoofer peak limit level setting (system setup menu), adjust the level as necessary. DTS Surround: ­10 dB to 0 dB When DTS encoded movie software is played, it is recommended that the LFE LEVEL be set to 0 dB for correct DTS playback. When DTS encoded music software is played, it is recommended that the LFE LEVEL be set to ­10 dB for correct DTS playback. sB CH OUT (Surround Back): "OFF" . Playback is conducted without using the surround back speaker. Playback is conducted using the surround back speaker. Playback is conducted using the surround back speaker. The same signals those of the surround channels are output from the surround back channels. Playback is conducted using the surround back speaker. Surround back channel is reproduced using digital matrix processing. Playback is conducted without using the surround back speaker. Playback is conducted using the surround back speaker. Surround back channel is reproduced using digital matrix processing. [. . . ] This technology is aimed mainly at multi-channel audio or video equipment including Dolby Digital or Dolby Pro Logic Surround decoding functions and operates inside a high performance digital signal processing chip (DSP). The Dolby Headphone mode can be used not only with multi-channel sources but also with stereo programs. Have you operated the receiver according to the Operating Instructions ?Are the speakers, turntable and other components operating property ? [. . . ]