User manual DENON DN-U100

[. . . ] AM-FM STEREO TUNER DN-U100 OPERATING INSTRUCTIONS BEDIENUNGSANLEITUNG MODE D'EMPLOI ISTRUZIONI PER L'USO INSTRUCCIONES DE OPERACION GEBRUIKSAANWIJZING BRUKSANVISNING SVENSKA ¢SAFETY PRECAUTIONS NEDERLANDS ESPAÑOL ITALIANO FRANCAIS DEUTSCH ENGLISH · DECLARATION OF CONFORMITY We declare under our sole responsibility that this product, to which this declaration relates, is in conformity with the following standards: EN60065, EN55013, EN55020, EN61000-3-2 and EN61000-3-3. Following the provisions of 73/23/EEC, 89/336/EEC and 93/68/EEC Directive. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN · ÜBEREINSTIMMUNGSERKLÄRUNG Wir erklären unter unserer Verantwortung, daß dieses Produkt, auf das sich diese Erklärung bezieht, den folgenden Standards entspricht: EN60065, EN55013, EN55020, EN61000-3-2 und EN61000-3-3. Entspricht den Verordnungen der Direktive 73/23/EEC, 89/336/EEC und 93/68/EEC. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. [. . . ] Pay attention to the following before using this unit: · Moving the unit To prevent short-circuits or damaged wires in the connection cables, always unplug the power supply cord and disconnect the connection cables between all other audio components when moving the unit. · Before turning the power operation switch (ON/STANDBY) on Check once again that all connections are proper and that there are not problems with the connection cables. Always unit the power switch to the standby position before connecting and disconnecting connection cables. · Store the operating instructions in a safe place. After reading the operating instructions, store them in a safe place as they could come in handy in the future. · Whenever the power operation switch is in the STANDBY state, the unit is still connected to AC line voltage. Please be sure to turn off the power operation switch or unplug the cord when you leave home for, say, a vacation. · Note that the illustrations in these instructions may differ from the actual unit for explanation purposes. 1 ENGLISH ENGLISH ENGLISH Getting Started Cautions on installation Noise or disturbance of the picture may be generated if this unit or any other electronic equipment using microprocessors is used near a tuner or TV. If this happens, take the following steps: · Install this unit as far away as possible from the tuner or TV. · Run the antenna wires from the tuner or TV away from this unit's power supply cord and input/output connection cables. · Noise or disturbance tends to occur particularly when using indoor antennas or 300 /ohms feeder wires. We recommend using outdoor antennas and 75 /ohms coaxial cables. Note Note: For heat dispersal, do not install this unit in a confined space such as a bookcase or similar enclosure. Wall Inserting the batteries q Remove the remote control unit's rear cover. Notes on batteries: · Replace the batteries with new ones if the unit does not operate even when the remote control unit is operated nearby the unit. (The included batteries are only for verifying operation. ) · When inserting the batteries, be sure to do so in the proper direction, following the "+" marks in the battery compartment. · To prevent damage or leakage of battery fluid: · Do not use a new battery together with an old one. · Do not use two different types of batteries. · Do not short-circuit, disassemble, heat or dispose of batteries in flames. · If the battery fluid should leak, carefully wipe the fluid off the inside of the battery compartment and insert new batteries. · When replacing the batteries, have the new batteries ready and insert them as quickly as possible. w Set two R03/AAA batteries in the battery compartment in the indicated direction. e Put the rear cover back on. 2 ENGLISH ENGLISH Getting Started ENGLISH Operating range of the remote control unit · Point the remote control unit at the remote sensor on the main unit as shown in the diagram. · The remote control unit can be used from a straight distance of approximately 7 meters from the main unit, but this distance will be shorter if there are obstacles in the way or if the remote control unit is not pointed directly at the remote sensor. · The remote control unit can be operated at a horizontal angle of up to 30 degrees with respect to the remote sensor. NOTE: · It may be difficult to operate the remote control unit if the remote sensor is exposed to direct sunlight or strong artificial light. [. . . ] If this unit is not operating properly, check the items listed in the table below. Should the problem persist, there may be a malfunction. Disconnect the power immediately and contact your store of purchase. Symptom Power does not turn on when ON/STANDBY switch is pressed. [. . . ]