User manual DENON DN-X800

[. . . ] The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. Handle the power supply cord carefully Do not damage or deform the power supply cord. If it is damaged or deformed, it may cause electric shock or malfunction when used. When removing from wall outlet, be sure to remove by holding the plug attachment and not by pulling the cord. [. . . ] In the MONO mode, mono CUE level is displayed on the Left meter and mono PROGRAM level is displayed on the Right meter. These RCA jacks are Inputs for any digital output device. This stereo pair of RCA jacks provide a unbalanced line level output. These stereo pairs of unbalanced RCA jacks are Inputs for any line level device. Connect these jacks to the Fader input jacks of the DN-1800F, the DN-2100F and the DN-2600F using the 3. In the STEREO mode it changes the relative levels of the Cue and Program mixed together in both earcups. In the MONO mode it changes the balance between the Mono Cue in the left ear cup and the Mono Program in the right. These stereo pairs of unbalanced RCA jacks are Inputs for a Phono (RIAA) stage for magnetic (MM) cartridges or a Line stage suitable for any device, such as a CD player. This function will start the performance of CD Player with Ch. Pressing multiple buttons makes it possible to derive mixed sound from the selected sources. When the red indicator is lit, the DN-X800 is ready to go. These XLR type connectors provide a balanced line level output with independent front panel Zone Level controls and are not affected by the Master Level control. NOTE: Do not short-circuit the hot or cold pin with the common pin. These switches change the Input from Phono to a Line level inputs. These switches set a Line level inputs when Turntable is not connected. This screws provide a place to connect the ground wire from a turntable. This terminal is exclusively for a turntable grounding and not a safety earth ground. Channels not assigned to A or B are output without passing through the crossfader. Accepts either a balanced microphone with an XLR connector or an unbalanced microphone with 1/4" mono jacks. This stereo pair of RCA jacks provide a unbalanced line level output with independent front panel Booth Level controls and are not affected by the Master Level control. When the fader is at its far left, only the A Mix is heard from the Outputs. as the fader is moved toward the right , the amount of B Mix is increased and the amount of A Mix is decreased. [. . . ] When the Crossfader is slid in the opposite direction as in "3", CD player play will begin. NOTE: Use the analog inputs/outputs when the DN-1800F, the DN-2100F and the DN-2600F are moved by FADER START. nOTES: · Channels selected with the Crossfader Assign A, B switches and the Crossfader Start A, B buttons cannot be started with the source input fader (Ch. Fader and Cross Fader switches are ON, priority will be the cross fader. [. . . ]