User manual DENON RC-897

[. . . ] TONE SURROUND PARAMETER TONE CONTROL RETURN STATUS MUTING DISPLAY CHANNEL TV VOLUME B REMOTE CONTROL UNIT RC-897 FOR ENGLISH READERS PAGE 2 ~ PAGE 48, 94, 95 POUR LES LECTEURS FRANCAIS PAGE 2, 49 ~ PAGE 95 2 We greatly appreciate your purchase of this unit. Be sure to keep this manual for future reference should any questions or problems arise. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. [. . . ] DVD/VDP DISC SKIP+ TITLE 8 3 9 1 Press the button for the program source to be played. To select the input mode from main unit. (In this case play the component connected to the “EXT. The mode switches as shown below each time INPUT MODE is pressed. AUTO DTS (Main unit) PCM Input mode selection function Different input modes can be selected for the different input sources. The selected input modes for the separate input sources are stored in the memory. (Main unit) • Selecting the AUTO , PCM and DTS modes. This mode can be selected for all input sources other than PHONO, CDR/TAPE and TUNER. The presence or absence of digital signals is detected, the signals input to the digital input jacks are identified and decoding and playback are performed automatically in DTS, Dolby Digital or PCM (2 channel stereo) format. If no digital signal is being input, the analog input jacks are selected. Use this mode to play Dolby Digital signals. W PCM (exclusive PCM signal playback mode) Decoding and playback are only performed when PCM signals are being input. Note that noise may be generated when using this mode to play signals other than PCM signals. E DTS (exclusive DTS signal playback mode) Decoding and playback are only performed when DTS signals are being input. R ANALOG (exclusive analog audio signal playback mode) The signals input to the analog input jacks are decoded and played. IN (external decoder input jack selection mode) The signals being input to the external decoder input jacks are played without passing through the surround circuitry. NOTE: • Note that noise will be output when CDs or LDs recorded in DTS format are played in the “PCM” (exclusive PCM signal playback) or “ANALOG” (exclusive analog audio signal playback) mode. Select the AUTO or DTS (exclusive DTS signal playback) mode when playing signals recorded in DTS from a laser disc player. Notes on playing a source encoded with DTS • Noise may be generated at the beginning of playback and while searching during DTS playback in the AUTO mode. € In some rare cases noise may be generated when you preform the operation to stop playback of a DTS-CD or DTS-LD. To select the input mode from the remote control unit. € The mode switches as shown below each time INPUT MODE is pressed. [. . . ] Should the problem persist, there may be a malfunction. Disconnect the power immediately and contact your store of purchase. Symptom DISPLAY not lit and sound not produced when power switch set to on. cause • Power cord not plugged in securely. [. . . ]