User manual DENON S-M73

[. . . ] Never disassemble or modify the set in any way. When moving this unit 2 Do not shock this unit. 2 Always check that the connection cords disconnected before moving this unit. To direct sunlight for long periods of time or near heaters or other heating equipment. [. . . ] 2 Do not use benzene, thinners, or other organic Solvents or insecticides on the main unit since they may cause a change in quality or color. When installing, carefully examine the place and method of installation for safety. , follow the instructions included with the stand and check for safety before installing and using. DENON will accept no responsibility for damages or accidents caused by the unit falling. The quality of the sound produced from the speaker system is affected by the size and type (Japanese or Western) of the room, as well as by the method of installation. Consider the points listed below before installing the speaker system. 2 If the bass sound is overemphasized when the 2 Please Stick the included anti-slip pads (cork, approximately 1mm thick) at bottom of the cabinet as below to prevent slipping. Speaker systems are installed directly on the floor, set them on concrete blocks or other hard stands. 2 Placing the speakers on a shelf or in a corner can boost the bass level of the speaker. If you want to reduce it, please place the foam plugs in the reflex port tubes that you can find on the back of the speakers. cAUTION: · The sound quality can be adjusted by changing the depth of the foam plugs in the ducts. Never insert the foam plugs deeper than the plate surface. If this is done, it may not be possible to get them out and they may fall inside the set. If the foam plugs should get stuck or fall inside the set, stop using the set immediately and contact your store of purchase or one of the service centers listed on the included "DENON Service Network". To ensure safety, do not place any objects on top or lean objects against the speaker system. The speaker may topple down or fall if force is applied to the sides. Be particularly careful to avoid this, as this could cause injury or other serious accidents. Fix connection cord to prevent being caught on it and making loudspeakers topping down. Stand or shelf as a record player may result in howling. , directly in front of or behind the speaker system, cover the wall or door with a thick curtain to prevent resonance and reflection. 2 The speaker systems are of the low-leakage-flux type and can be used near televisions, but depending on the TV there may be color blotching on the picture. If this happens, turn off the TV's power, wait 15 to 30 minutes, then turn the TV's power back on. [. . . ] Connections (The red terminals on the right side are the "+" terminals, the black ones on the left side the "­" terminals. ) CAUTION: · Be careful to interconnect the positive (red(+)) and negative (black(­)) sides and the left and right speakers properly. To prevent circuit problems, never short-circuit striped and plain core wires or the left and right cords. * The net on the front of the speaker systems can be removed. [. . . ]