User manual DENON S-76HT

[. . . ] The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. A NOTE ABOUT RECYCLING: This product's packaging materials are recyclable and can be reused. Please dispose of any materials in accordance with the local recycling regulations. When discarding the unit, comply with local rules or regulations. [. . . ] 2 When mounting the satellite speaker system (SCA76) on a stand or bracket, you can use M5 nuts inserted into the bottom of the satellite speaker system (SC-A76) at intervals of 60 mm. When mounting, following the instructions in the manual included with the speaker stand or ceiling mount bracket, and be sure to install properly and securely. To ensure safety, do not place any objects on top or lean objects against the speaker system. The speaker may topple down or fall if force is applied to the sides. Be particularly careful to avoid this, as this could cause injury or other serious accidents. When installing the speaker systems on the ceiling or wall, to ensure safety, have specialists do the installation work. Be sure to fasten the speaker cords to a wall, etc. , to prevent people from tripping over them or otherwise pulling on them accidentally, causing the speaker systems to fall. Be sure to check for safety after installing the speaker systems. Afterwards, perform safety inspections at regular intervals to be sure there is no danger that the speaker systems will fall. DENON will accept no responsibility for damages or accidents caused by inappropriate choice of the place of installation or improper installation procedures. The SC-C76 can be mounted on a wall using the key hole hooks on its rear panel. To do so, install the two screws in the wall at a distance of 126 mm from each other (equal to the distance between the wall-mount bracket holes on the SC-C76's rear panel). Once the screws are installed in the wall, insert onto the heads of the screws. Be sure to mount to a solid wall strong enough to support the weight of the speaker system. Note that DENON will accept no responsibility for damages due to the speaker systems falling. If the speaker system is set in an unstable place, it could tip over or fall, possibly resulting in serious accidents. , due to interaction with the speaker system if there is a magnet or an object generating magnetic force nearby. (c) When toys or other objects using magnets are placed nearby. 2 Note that the illustrations in this instructions may differ from the actual set for explanation purposes. 2 Be sure to keep the operating instructions. After reading these operating instructions, store them in a safe place. [. . . ] When turning the power off, set the unit's power switch to the "OFF" position before turning off the AV surround receiver's (or amplifier's) power. The net on the front of the speaker systems (SC-A76, SC-C76) can be removed. To remove, grasp both sides of the net and pull forward. To mount, line up the holes in the four corners of the speaker net with the projecting pieces in the four corners of the cabinet and press in. [. . . ]