User manual DENON TU-1500AE

[. . . ] We declare under our sole responsibility that this product, to which this declaration relates, is in conformity with the following standards: EN60065, EN55013, EN55020, EN61000-3-2 and EN61000-3-3. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. To completely disconnect this product from the mains, disconnect the plug from the wall socket outlet. When setting up this product, make sure that the AC outlet you are using is easily acceptable. [. . . ] Turn the knob clockwise to raise the frequency, counterclockwise to lower the frequency. Use the knob together with the MENU button to switch the mode setting. ( page 10 ~ 16) MEMO · Whenever the unit is in the STANDBY state, the unit is still connected to AC line voltage. Please be sure to unplug the power supply cord when you leave home for, say, a vacation. Noise may be generated if a nearby television set is on during the broadcasting reception. The tuner should be used as far away from a television as possible. The unit is also equipped with a back-up memory. This function provides memory storage when the power switch is off and with the power supply cord disconnected. This lights when receiving RDS broadcasts, and flashes during the RDS search. This lights when the TU-1500AE's power is in the "on" or "standby" mode. The display's brightness can be adjusted in three steps. Press this button to switch the brightness between high, medium and low, in that order. Press this button to switch the band between FM and AM. 75 /ohms coaxial cables can be connected to these terminals. ( page 6) Connect with this terminal when a medium wave outdoor antenna is used. Press this button to switch from the standby mode to the operating mode. Use these when presenting and recalling stations. Also use these with the SHIFT and MEMORY buttons to use a total of 100 preset channels, A (1 ~ 10), B (1 ~ 10), . Use the SHIFT and the CHANNEL buttons during this time to designate the desired preset channel. This button is used to select the display mode. This button is used to select radio presets. Use this button to select the memory blocks, A (1 ~ 10), B (1 ~ 10), . [. . . ] If no RDS station are found with the above operation, all the reception bands are searched. When a broadcast station is found, that station's name appears on the display. If no other RDS station is found when all the frequencies are searched, "NO RDS" is displayed. If there is no station broadcasting the designated programme type with the above operation, all the reception bands are searched. [. . . ]