User manual DEVILLE ARCHE

[. . . ] 19 12 We strongly recommend reading carefully the entire manual in order to ensure the best possible use and the highest satisfaction from your Deville stove. Any non compliance with the assembly, installation and operating instructions is the sole responsibility of the person performing any operation on the stove. All local, national, and European regulations must be respected when using this appliance. wE RECOMMENDED ASKING A QUALIFIED PROFESSIONAL TO INSTALL THE STOVE. [. . . ] To the right with After lighting the appliance, to return to normal, intermediate or reduced burning position (see Fig. 3), use the poker to push the air damper operating knob as it may be hot. - Place crumpled paper on the grating and very dry kindling wood (twigs), then larger crosssection cut wood (diameter 3 to 5 cm). - Light the paper and close the door (leave it partly open to accelerate lighting up). - Once the "kindling wood" load is burning, open the door, load the appliance with the recommended fuel and use the regulation devices to obtain the burning required. 1 Periodic and continuous use - The intermittent use of the appliance requires a reload every 45 minutes. This type of use is particularly recommended as it environmentally friendly. - The apparatus may also be used in continuous mode when periodic use is not possible or when reduced burning is required. In this case, maximum heat output can be maintained for 3 hours and with a slow combustion rate, and a low heat output, the burning period can extend to 10 hours with a 9 kg load. 2 Fire duct - The burning required is obtained by using the control devices (see § 4. 3) and selecting a load matching your needs, i. For maximum heating, load the appliance with 3 logs of approx. Use this position only temporarily, to heat the rooms following prolonged absence. For intermediate heating, use a smaller load : one or two logs (air damper half-open) (Fig. For a long-lasting heat output with a slow combustion rate, use 1 or 2 non-split logs with a diameter superior to 15 cm (air damper closed) (Fig. - To get a long-lasting combustion rate, reload on a merely burning bed of embers. - For rapid restarting of the fire, add some kindling wood, load the logs, and only if necessary keep the door partly open for several minutes, without leaving the appliance unattended. Thereafter, use the controls as per the instructions (paragraph 4. This method gets the fire going quickly again, especially if the wood is slightly damp. - Change the burning rate (switching from a slow combustion rate to a normal rate for example) before reloading, during the combustion stage of the embers, to enable the appliance and smoke duct to change progressively from one burning rate to another. 16 - To prevent smoke from driving back and the ash from entering the room, at the time of loading, opening the door requires a number of precautions: . Open the door partly, waits for the open door suction to start, and open the door slowly. [. . . ] - Clean the appliance using a brush and a vacuum cleaner. In the event of an anomaly : have the appliance repaired or the installation performed by a qualified professional. After a long off-period : - Check that nothing obstructs any pipes before using the stove again. CURRENT MAINTENANCE - Clean the window using a damp cloth and ash. [. . . ]