User manual DEVILLE C07832 04-05

[. . . ] 1 - Ventilation of the area in which the appliance is to be installed 4. You are advised to read carefully and in full the information provided in order to get the best performance - and the most satisfaction - out of your DEVILLE stove. Failure to comply with the assembly, installation and operating instructions places all responsibility upon the person(s) concerned. Net weight of the appliance Stripped weight (less door, deflector, grate, backplate) 1 - Surrounds Your Insert-stove can be installed within either an existing fireplace or a new DEVILLE fireplace. [. . . ] Any other combustible than wood is forbidden, in particular coal and its by-products. The burning power given is the average burning power obtained with each 2 hours load. ⷠSlow combustion in continuous use : Obtained on a 6 Pa draft with a 9 kg-load composed of a non-split log of strong wood, preferably with large diameters (superior to 16 cm). 2, 5 cm thick), with the air setting completely closed. For the versions with thermostat, select automatic operation (AUTO) or manual operation (MANU) with the selector 14 : - In the MANU position : the fan is switched on and off by manual control. In this position, the blower function can be started up immediately and must be switched off by hand. - In the AUTO position : the fan is operated automatically, when the whole of the apparatus is warm, generally during the following hour the lighting. Its running is interrupted when the apparatus is cold, generally at the fireplace's extinction. If you want the blower to be started up immediately and then switched off automatically, select the MANU position when lighting and then switch to the AUTO position once the appliance is hot. The blower will then be switched off automatically. 2 ­ Working with door closed · Use the damper to adjust the stove to the rate at which you want the wood to burn (see Fig. The amount of wood you put in depends on the heating rate you require : see 4. For a very long heating period at reduced heat, put the logs on top of embers that are giving off very little glow. To get the stove going quickly, put in some kindling. If necessary, leave the door ajar for a few minutes (keep an eye on the stove) and then shut the door. This will speed burning up and is especially useful if the wood is at all wet. While the embers are recatching, before reloading change the damper control (e. Normal to low) so that the stove and the smoke flue can gradually adjust. To avoid any smoke being discharged or ash falling into the room when recharging the fire, the following precautions must be taken when opening the door: Switch off the fan to avoid drawing in ash which may then fall from the front of the appliance. Open the door slightly, wait a few moments for the draught to be established in open door mode, and then slowly open the door. In mild periods and if using wet wood, slow burning at low speed can result in incomplete burning which causes deposits of soot and tar. To avoid this, alternative between low and normal speed. [. . . ] remove the 2 fixing screws of the blower. Take the blower out by pulling the grid. Make sure the catch-bolt on the door works properly ; if necessary, adjust as follows (Fig 16) : To tighten the catch: . Give both screws a quarter turn and repeat if necessary. [. . . ]