User manual DEVILLE C07886 1-07

[. . . ] The damper situated in the lower part of the door is used to adjust the fuel burning rate. A secondary air intake is integrated in the top part of the glazing to keep it clean and to assure a better combustion of wood. 1 Environment The hearths C07897 and C07886 are meant to be set up in a new fireplace DEVILLE. 3 Setting up of the appliance is optional This kit must be assembled before setting up the hearth in the fireplace and according to the instructions enclosed with this option. [. . . ] Push the damper towards your left until it stops (Fig. - Screw up some paper and place it on the grate along with some very dry kindling with some bigger split wood on top (diameter about 3 to 5 centimetres). - As soon as the kindling load is burning, open the door, and load the appliance with the recommended combustible, then close the door and put the air setting damper in position , or according to the level of power you wish to get (Fig. 1 Working with door closed - The speed you want to get is obtained by moving the air setting damper (see paragraph 5. 3) and by choosing a load according to your needs, being : . For maximum heat, put in 3 logs with a diameter of about 12 cm, . For medium heat, just put in one or two logs, 14 For a longer heating period at low speed, put in one or two non-split logs a diameter greater than 15 cm. For slow burning over a long period, put the logs on top of a bed of embers that are giving off very little glow. - To obtain a quick regain, after a slow speed, boost the fire with kindling, make a loading, place the air adjustment damper in position (A) Fig. 9a and 9b during a few minutes to speed up the burning, keeping the appliance under close control, then close the damper. This method gets the fire going quickly again, especially if the wood is slightly damp. - Carefully check the condition of the appliance, and more especially smoke-tightness : seals, fixings, and door and frame. - Check the condition of the smoke flue and the connecting pipe ; all fittings should be in good mechanical condition and be smoke-tight. - Clean the extractor fan inside the hood to get rid of any dust and if necessary clear the hot air convection system. If necessary, use an adapted household cleaning product respecting the instructions on the direction for use. Wait until the stove is completely cool before cleaning. Take off from the fan (following the pointers) guides and the glass (Fig. Use the end of some metal object soot (Fig. Particles and dust that are stuck between the air To scrape the bottom edge of the damper so as to remove any Any soot or other particles are liable to prevent the formation of the secondary film of air protecting the glass from direct contact with the smoke and ensuring full combustion of the wood. Cleaning should be done as soon as the glass is dirty and in any event must be done when the stove is completely out. - Clean the hot air grilles in the hood at regular intervals. How often you do this depends on the grilles : the smaller the holes, the quicker they get clogged up. [. . . ] Whenever claiming under a warranty, the guarantee with the stamp from the retailer Deville is strictly required. The above guarantee must be produced for any demand to repair the appliance under warranty, or a detachable slip or coupon of any such guarantee must, according to the own organisation of Deville, be returned to the latter within the required time. For lack of this, the date on the invoice issued by Deville can't be taken into account. WARRANTY PERIOD The agreed warranty period assured by Deville is the longer of 1 year from the day of the purchase of the appliance, subject to the above terms and conditions are fact that the claims covered by the conditions are requested within the required time. [. . . ]