User manual DEWALT DW160V

[. . . ] 3 Guard against electric shock Prevent body contact with earthed surfaces (e. High humidity, when metal swarf is being produced, etc. ) electric safety can be improved by inserting an isolating transformer or a (FI) earth-leakage circuit-breaker. 4 Keep children away Do not let children come into contact with the tool or extension cord. [. . . ] Do not force small tools or attachments to do the job of a heavy-duty tool. The tool will do the job better and safer at the rate for which it was intended. The use of any accessory or attachment or performance of any operation with this tool, other than those recommended in this instruction manual may present a risk of personal injury. 17 Do not abuse cord Never carry the tool by its cord or pull it to disconnect from the socket. Keep the cord away from heat, oil and sharp edges. 18 Maintain tools with care Keep the tools in good condition and clean for better and safer performance. Keep all controls dry, clean and free from oil and grease. 19 Check for damaged parts Before using the tool, carefully check it for Check for misalignment and seizure of moving parts, breakage of parts and any other conditions that may affect its operation. Have damaged guards or other defective parts repaired or replaced as instructed. 20 Have your tool repaired by an authorized DeWALT repair agent This Power Tool is in accordance with the relevant safety regulations. to avoid danger , electric appliances must only be repaired by qualified technicians. Your DeWALT tool is double insulated in accordance with prEN 50144; therefore no earth wire is required. Should your mains plug need replacing and you are competent to do this, proceed as instructed below. If you are in doubt, contact an authorized DeWALT repair agent or a qualified electrician. Cut off the plug and dispose of it safely; a plug with bared copper conductors is dangerous if engaged in a live socket outlet. Only fit 13 Amperes BS1363A approved plugs fitted with the correctly rated fuse (1). The cable wire colours, or a letter, will be marked at the connection points of most good quality plugs. Before replacing the top cover of the mains plug ensure that the cable restraint (3) is holding the outer sheath of the cable firmly and that the two leads are correctly fixed at the terminal screws. The package contains: 1 Heavy duty right angle drill 1 Chuck key 1 Chuck key holder 1 Instruction manual 1 Exploded drawing 1 Registration card · Check for damage to the tool, parts or accessories which may have occurred during transport. Take the time to thoroughly read and understand this manual prior to operation. Your DeWALT Heavy Duty Right Angle Drill is a professional Power Tool that has been designed especially for drilling in confined spaces. 1 Chuck 2 Paddle switch 3 Tool housing 4 Chuck key holder 5 Chuck key 6 Pilot hole 7 Chuck guard 8 Chuck jaws Never use a light socket. [. . . ] Fit the chuck key (5) to the chuck key holder (4) as shown. Cleaning Keep the ventilation slots clear and regularly clean the housing with a soft cloth. Always observe the safety instructions and applicable regulations. Take your tool to an authorized DeWALT repair agent where it will be disposed of in an environmentally safe way. [. . . ]