User manual DEXAPLAN CA 616 8-2006

[. . . ] Please read the operating instructions thoroughly and carefully before initial operation of the device and open out the pages showing the illustrations and figures. the instruction manual is part of this product and contains important information relating to initial operation and handling. Please always observe all safety instructions. Before initial operation, please check that all parts are fitted correctly. [. . . ] The items described below are not supplied with the device. This information and dimensions are given for guidance only and may not be appropriate in all cases. The quality of materials required should be selected to suit the situation at the installation site. V type LR6 (mignon / AA, alkaline) (not included) for the power supply to the control unit and the external siren. When you install the fastenings make sure That you do not damage any cables or pipes carrying gas, electricity, water or telecommunications. damaging gas pipes may lead to danger of explosion and to life. A damaged electricity cable may result in loss of life by electric shock. Damage to water pipes may lead to property damage. To locate any cables or pipes use an appropriate detector or seek the advice of an expert. Ensure before you install the sensor and the external siren that the cable is long enough for the distances to be traversed. Ensure that the cable cannot become drawn over sharp edges or become squashed or trapped. O Place the battery holder } back into the battery compartment of the control unit and reattach the rear T of the battery compartment with the fastening screws Y. Push the top mounting point U over the top screw head at the same time as you push the bottom mounting point { over the bottom screw head. Readjust the screw heads if this is necessary to obtain a secure seating for the device. Ensure that the sabotage contact I (on the rear of housing) is pressed and lies flush against the installation site surface. If you need to drill a cable feed hole for the external siren then you should ensure that the hole is hidden behind the siren housing. ensure the hole is big enough for the socket connector of the cable w. Guide the cable of the siren from the outside through the hole and connect the plug to the control unit as described above. Mark two holes 60 mm apart at the selected position. Drill the two holes for the two dowels (2 x 6 mm) and insert the dowels into the holes. Screw the two mounting screws (22 x 4 mm) into the dowels until the screw heads project approx. V type LR6 (mignon / AA, alkaline) observing the correct polarity (helical spring to the negative pole of the batteries) into the battery holder y. [. . . ] Fault The compact alarm system does not work or is not working properly. Remedy Replace the old batteries with new ones. In accordance with European Directive 2002 / 96 / EC (covering waste electrical and electronic equipment) and its transposition into national legislation, worn out electrical devices must be collected separately and taken for environmentally compatible recycling. Take out the batteries before you dispose of electrical devices. [. . . ]