User manual DEXAPLAN DV 622 MANUAL 1 DU 18-10-2007

[. . . ] Use a slightly moist cloth, using a little detergent if necessary, for cleaning the surfaces. Do not use any chemicals. Disposal Do not dispose of packaging material, used batteries or products as household waste. Details are available from your local authority. cover, wear and tear or damage to fragile parts. The product is intended solely for private use and not for commercial use. [. . . ] You can improve the quality of the image at night by using additional illumination. The camera automatically switches to black and white in low light conditions and in artificial light. If you want to install the camera outdoors, then ensure there is a suitable possible cable routing at the installation location. Protect the camera against direct rainfall if possible. !! Location of the event recorder Observe the following points: !Pay attention to the space required for the plug connections to the event recorder. If you want to observe live images, place the event recorder near the TV or the video monitor. When choosing the location of the recorder consider the cable lengths for the TV or video monitor, for the mains power socket and for the camera. !Remove the equipment and the accessories from the packaging. Peel off the protective film from the rear side of the event recorder. Connect the components as follows (see Fig. Connect the plug of the camera [23] to the socket [24c] of the connection cable. Press the connector into the socket until you hear it click in place. Connect the yellow plug [24a] of the connecting cable to the camera input CH1 [15] of the event recorder. Connect the black power supply socket [24b] of the connecting cable to the plug [22a or 22b] of the low voltage distribution cable. Connect the power supply socket [22c] of the low voltage distribution cable to the cable connector of the power supply [19]. Connect the plug [22d] of the low voltage distribution cable to the power supply connection [17] of the event recorder. Connect one of the plugs of the video output cable [20] to the video output [16] of the event recorder. Connect either: # the free plug of the video output cable to the AV (cinch) video input of a video monitor or television; # or connect the free plug of the video output cable to the yellow "VIDEO" socket of the SCART adapter. Plug the SCART adapter into the SCART connection of your television. The connection to a television or a video monitor is not required during recording, however it is necessary for the basic configuration. Connection Mounting the camera You can align the camera as desired using the arm of the bracket which you can rotate by 360° and by turning and swivelling the ball joint (see Fig. Wall / ceiling mounting of the camera If the cable [30] is laid under plaster, the cable opening [28: opening in wall for cable, Ø approx. [. . . ] Behaviour in case of power failure and/or after switching off The selected settings are maintained after switching off the event recorder or in the case of power failure. If a power failure lasts longer than approx. 12 hours, the date and time will be reset to the factory settings. After restoring the power supply, channel 1 (CH1) is always automatically selected. Tip: The event recorder has no means of time-controlled recording; instead it records when motion is detected. [. . . ]