User manual DEXAPLAN H A621 9-2007

[. . . ] The heat detector will only function when a correct and good condition battery is correctly inserted. Unless there is a legal responsibility, no liability will be accepted for any damages in particular to persons or property caused by non-functioning or incorrect functioning of the heat detector. Smoke and heat detectors are no substitute for your duty of supervision and care, and are no substitute for property or life insurance. You are responsible for provision of adequate insurance cover. [. . . ] - if the surface of the door is cool, then hold your shoulder against the door and open it carefully a few centimetres. If you can see smoke or flames then close the door. Call the fire brigade as soon as you have left the house. Give your exact address and wait at the roadside until the fire brigade arrives. O Remove the heat detector from the bracket by turning it counter-clockwise. O Remove the used battery from the heat detector. O Place a new battery into the battery compartment so that the battery polarity is correct for the battery contacts R (see +/- marking on the back of the housing). O Place the heat detector onto the bracket so that the ends of the bracket fit into the recesses for the bracket E. O Push the heat detector slightly upwards and turn it clockwise until it locks. O Test the function of the device immediately after the battery replacement by pressing the test button U for up to 4 seconds until the alarm sounds. Information on dealing with common problems can be found at www. If you have any questions, please contact our service office by email (service@dexaplan. 00 h) Here you can obtain all necessary information on service questions such as returns, etc. The following instructions are for your own safety when installing and operating the heat detector. Please note that non-compliance with these safety instructions leads to a serious risk of danger. Do not leave small children unsupervised with the packaging material, the device or with any small parts. O not damage any gas, electricity or telecommunication lines when D fitting the device. Danger to life, risk of injury and damage!Nsure that the battery is inserted with the correct polarity. Ensure that the E battery is not short circuited or exposed to excessive heat such as sunshine or fire. The battery must also never be recharged. Make sure that your hearing is not exposed to the loud alarm signal for any length of time and that the signal is not triggered close to the ears. [. . . ] O Test the heat detector weekly, for example when cleaning, by pressing the test button U for up to 4 seconds until the alarm sounds. O Use a dry and soft cloth to clean the surfaces of the device. O Carefully clean the heat detector every 6 months using a vacuum cleaner. O If the heat detector is damaged it must be replaced. [. . . ]