User manual DEXAPLAN MA 604 7-2006

[. . . ] Mini-alarm MA 604 A T Dexaplan Q W E R U Y B O I P { } C 10 m 100° D 2° 6m 10 m 100° A604_GB. indd 1 T 62 12. 09. 2006 11:32:33 U Operating and safety instructions Introduction Please read these operating instructions thoroughly and carefully. They are part of this product and contain important instructions relating to its operation and handling. Please always observe all safety instructions. Before initial operation, please check that all parts are fitted correctly. [. . . ] Install the device so that no heat sources such as radiators or air ducts are situated in the range of the sensor. When activated, the mini-alarm could register the temperature emitted by these objects as movements by heat-emitting bodies. Use the device at normal room temperatures only. Higher or lower temperatures can impair its function. Initial operation Tip: the mini-alarm reacts sensitively and quickly to movements crossing its sensing range. It reacts less sensitively to movements directly towards the sensing range (see Fig. You can use the mini-alarm to indicate movements of welcome (e. g. family members) and unwelcome visitors (e. g. You can choose between a two-tone chime and an approx. The device can be used horizontally for an area and vertically for a point of entry ("curtain effect") in the monitored room (see Fig. The mini-alarm can be used as a door bell by connecting it to a bell push or other closing contact contact with the bell push contact cable. A604_GB. indd 4 12. 09. 2006 11:32:34 U Preparation and material required The stated materials are not included in the delivery scope. The information provided here is non-binding and intended as a guide. The quality of the material depends on individual local requirements. You will need: o Either a 9 volt block-battery 6LR61, alkaline, or a 9 volt mains adapter, min. 200 mA (positive internal pole of the plug) for power supply (not included in the delivery scope). o A pen to mark the installation position. o A crosstip screwdriver for installation with the fastening screws. Power supply m Caution! o o o o o Operate the device with a 9 V block-battery (6LR61, alkaline) or a 9 volt mains adapter only. Make sure that the battery is inserted with the correct polarity. Remove the battery from the device for long periods of non-use. Use new batteries only and under no circumstances used ones. Make sure before connecting a 9 volt mains adapter to the mains power supply that the mains current is 230 V ~ 50 Hz and has a max. 16 ampere fuse in accordance with regulations. 9 volt block-battery o Set the function switch R to position 0. o Remove the battery compartment cover } completely from the reverse side of the mini-alarm casing Q (see Fig. [. . . ] Monitoring of the sensing range is deacctivated. o o 0 o o A604_GB. indd 6 12. 09. 2006 11:32:35 U Connecting an external bell push or other closing contact. m Danger o Do not connect any other energy source to the socket of the bell push contact cable. Otherwise there is danger to life and a risk of fire. Install it so that it cannot get damaged and does not create a stumbling hazard. [. . . ]