User manual DICOTA DATABOX ALLROUND XL

[. . . ] For more information please consult your dealer or check www. Com for information which Notebooks are compatible. In general, please take care to operate your DataBox Allround XL on a stable and skid-fast surface. [. . . ] 1) 2) 3) 4) 5) 6) 7) 8) 9) 1 x 220 V power socket, cable tree 2 x EURO 8 and 2 x IBM Detachable cable pouch Detachable CD case Detachable accessory pouch 8 x 3M Velcro pads (self-adhesive) Lockable box, 2 x key Separate document case Individually adjustable Notebook pads Cable tree cover 1) 2) 3) Detachable CD case with business card holder Detachable accessory pouch Detachable cable pouch 1) 2) 3) Printer lid can be opened Permanently installed cable tree Individually adjustable front and back side for Notebook mounting If you have not ordered the , , QuickFix" printer holder for your specific printer, proceed as follows 1) 2) Take eight Velcro pads and press two corresponding pairs together (Fig. 3) Now you have four Velcro pairs with protective films on each side. Remove the protective film on one side of each pair to reveal the adhesive tape beneath and press them to one corner each of your printer. Before you mount the printer, please check the intended position on the flap since incorrect mounting can cause problems during printer operation. 3) Now you can mount the printer on the open front lid of the DataBox Allround XL by removing the protective film from the four Velcro pairs and position the printer on the lid. After mounting the printer, leave the lid open for at least twelve hours so the tape really sticks. The printer must first be shoved into the , , QuickFix" holder (Fig. The holder with the printer is then placed on the printer lid and connected to the other holders (Fig. 6 (3)) must be fully inserted into the holders on the printer lid. Due to the fact that DataBox Allround XL is based on the "Floor-to-Desk" system and the Notebook is operated on a table outside the case, the installation of the printer to the Notebook must be done according to the standard installation procedure of the printer or Notebook. How to connect the Notebook with the printer is explained on the following page! the optional , , QuickFix" holder is suitable for many standard printers. If you have any questions, please contact us at info@dicota. *Depending on the printer, there may be other , , QuickFix" holders similar to the one shown!There are two options for connecting the Notebook to your printer: 1) Connect printer and Notebook with a USB cable. This cable is not included in the DataBox Allround XL! [. . . ] 6 (3)) closes the storage space for power supply units and protects it inside the DataBox Allround XL. Place the power supply units that belong to your Notebook and printer into this compartment. Lead the cables through the left and right sides of the lid (Fig. [. . . ]