User manual DIGITECH BNX3

[. . . ] GENETXTM BASS WORKSTATION USER'S GUIDE WARNING FOR YOUR PROTECTION PLEASE READ THE FOLLOWING: KEEP THESE INSTRUCTIONS HEED ALL WARNINGS FOLLOW ALL INSTRUCTIONS Do not use this apparatus near water These symbols are internationally accepted symbols that warn of potential hazards with electrical products. The lightning flash means that there are dangerous voltages present within the unit. The exclamation point indicates that it is necessary for the user to refer to the owners manual. These symbols warn that there are no user serviceable parts inside the unit. Do not attempt to service the unit yourself. Refer all servicing to qualified personnel. [. . . ] This mode is great for laying down a dry bass amp track without modulation, delay, or reverb effects but still monitoring these effects out the BNX3's outputs while recording. REAMP 1-8 ­ Select one of these inputs to route the selected track back through the current BNX3's preset. This is great for bass tracks that were recorded using bass DRY or bass AMP because you can experiment by playing these tracks back through different amp models, effects, or entirely new presets. This is exactly how professional recording engineers mix down bass tracks. To select the input configuration for recording, follow these steps: 1. The BNX3's main display reads recinput. The display flashes the selected input configuration. Use the DATA WHEEL to select one of the 10 different input configurations you want to use for recording. NOTE: When the STOP button is pressed after using the reamp input configuration for recording, the input configuration will automatically be reset to bass. Stereo Record The recorder can be setup to automatically arm pairs of tracks for recording in stereo. When Stereo Record is enabled, each time you press the RECORD button or footswitch, the recorder will automatically arm a pair of tracks to record to. Each track is automatically panned hard left and hard right respectively to maintain a stereo image. Track 1 is paired with track 2, track 3 is paired with track 4, and so on. To use Stereo Record, follow these steps: 40 Recorder 1 00 00 sterorec OF 1. Press the SETUP button until the BNX3's main display reads sterorec Of. Use the DATA WHEEL to turn the Stereo Enable feature on and off. This feature doesn't affect track arming when using the recorder panel. You can arm two tracks using the track buttons. When two tracks are armed for recording using the panel, they are automatically panned hard left and right. Click Track The Click Track keeps time when the recorder is recording. When Click Track is enabled, a metronome is set to the selected songs tempo while recording. To setup the Click Track, follow these steps: 1 00 00 clicktrk OF 1. Press the SETUP button until the BNX3's main display reads clicktrk Of. Use the DATA WHEEL to turn Click Track on and off. 4. When finished, press EXIT. Drum Pattern The Drum Pattern sets which drum pattern is used for playback when the Drums button is enabled (Green LED is lit) on the recorder panel. [. . . ] 20 Hz - 20 kHz +0 dB, - 1 dB > 95 dB A-weighted; ref = max signal, 22kHz measurement bandwidth. 120 VAC, 60 Hz 100 VAC, 50/60 Hz 230 VAC, 50 Hz 240 VAC, 50 Hz Adapter: PSS3-120 Adapter: PSS3-100 Adapter: PSS3CE-230 Adapter: PSS3-240 18. 5 Watts Length 20. 75" Width 9" Height 3" 8. 9 lbs. 75 Appendix Trouble Shooting Guide PROBLEM Recorded tracks cannot be heard on playback. SOLUTIONS Check analog output configuration in Utilty section. Verify recorded tracks are lit GREEN during playback. [. . . ]