User manual DIGITECH DIGIVERB

[. . . ] Sandy Parkway Sandy, Utah 84070, USA Date: April 12, 2002 European Contact: Your local DigiTech Sales and Service Office or Harman Music Group 8760 South Sandy Parkway Sandy, Utah 84070 USA Ph: (801) 566-8800 Fax: (801) 568-7583 IEC 60065 (1998) EN 55013 (1990) EN 55020 (1991) WARRANTY: We at DigiTech are proud of our products and back-up each one with the following warranty: 1. The warranty registration card must be mailed within ten days after purchase date to validate this warranty. DigiTech warrants this product, when used solely within the U. S. , to be free from defects in materials and workmanship under normal use and service. DigiTech liability under this warranty is limited to repairing or replacing defective materials that show evidence of defect, provided the product is returned to DigiTech WITH RETURN AUTHORIZATION, where all parts and labor will be covered up to a period of one year (this warranty is extended to a period of six years when the product has been properly registered by mail or through our website). A Return Authorization number may be obtained from DigiTech by telephone. The company shall not be liable for any consequential damage as a result of the product's use in any circuit or assembly. [. . . ] EQ Knob Controls the amount of high frequency boost or cut in the reverb signal. Turn this knob clockwise to boost high frequencies, and counterclockwise to reduce high frequencies. 1 234 5 11 10 9 6 7 8 3. AC Adapter Jack Connect a DigiTech PS200R power supply to this jack. Use the proper supply for your area's Mains line voltage. Decay Knob Controls the amount of reverb decay time. Turn the knob clockwise to increase the decay time and counter-clockwise to decrease the decay time. 5. Type Knob Selects one of seven different studio quality reverb types including Room, Plate, Hall, Church, Gated, Reverse, and Spring. Input Jack Connect your instrument to this jack. Connecting a guitar cable to this jack supplies battery power even though the Indicator LED may not be lit. To prolong battery life, disconnect all cables from the pedal when not in use. 7. Pedal Release Pins These two pins are spring-loaded hinges that hold the pedal in place. Push these pins in to release the pedal from the pedal chassis exposing the battery compartment. Pedal Press the pedal to turn the effect on and off. Out 1(Mono) Jack Connect this output to a single guitar amplifier when only one amp is being used. Indicator LED This LED lights when the effect is turned on. If the LED becomes dim or does not light when the cables are connected, the battery needs to be replaced. Out 2 Jack Connect this output to a second amplifier for stereo reverb. Stereo is the best way to get the most effective reverb experience from the DigiVerb pedal. Connections The DigiVerb has a single input and a pair of outputs. [. . . ] Using the tip of a 1/4" guitar cable, push one of the release pins in on either side of the pedal, and remove the pedal from the pedal chassis. Remove the battery from the battery compartment and disconnect the battery cable. Connect a new battery to the battery cable and put it back in the battery compartment. Make sure the battery cable does not interfere with the spring or pedal switch arm. [. . . ]