User manual DIGITECH IPS33B

[. . . ] do not attempt to service the unit yourself. refer all servicing to qualified personnel. opening the chassis for any reason will void the manufacturer's warranty. if liquid is spilled on the unit, shut it off immediately and take it to a dealer for service. [. . . ] You can set a tempo by tapping the teMPo/stoP footswitch. Adjust the RHYtHM LeVeL knob to a suitable volume. The teMPo/stoP footswitch will now be flashing at the set tempo (see page 42). (Optional) Set the Time Signature to something other than 4/4, if desired (see page 40). Press the Rec/PLaY/oVeRDUb footswitch and begin playing or singing to start recording. If a tempo has been set, there will be a single measure count-in indicated by the teMPo footswitch before recording begins. The Rec/PLaY/oVeRDUb footswitch will then light solid red, the LOOP LED will light, and recording will start. If no tempo has been set, recording will begin instantly after the Rec/PLaY/oVeRDUb footswitch is pressed and you begin playing. When you are ready to set the loop point for your phrase, press the Rec/PLaY/oVeRDUb footswitch to set the loop point and have the phrase play back in a repeating loop. The Rec/PLaY/oVeRDUb footswitch and PLaY status LEDs will light solid green. Press the teMPo/stoP footswitch to stop the loop playback. 3. Use the seLect knob or the LooP UP/LooP DoWN footswitches to select a previously recorded Loop phrase, or use a newly recorded phrase that has not yet been stored. The LooP LED must be lit if a previously recorded phrase is selected. If the caRD MeM LED is lit, you have selected a loop on the optional memory card. This footswitch and the PLaY status LEDs will light solid green and the phrase will begin playing. Press and release the Rec/PLaY/oVeRDUb footswitch again to begin overdub recording. This footswitch and the oVeRDUb status LEDs will now light solid yellow and any audio introduced on the selected input will be added to the audio the playback. When you have an overdub you are happy with, press the Rec/PLaY/oVeRDUb footswitch to disable overdubbing and continue playback (this footswitch and the PLaY status LEDs will light solid green). 2. 3. 4. You can continue adding overdubs by continuing to press the Rec/PLaY/ oVeRDUb footswitch. Each time an overdub is added, the last overdub is merged with the original loop and it can no longer be undone using the Undo functions (see page 32). Once you are finished with overdubbing, press the teMPo/stoP footswitch to stop playback/overdubbing. NOTE: Changing loops discards any overdubs that have not been stored to memory. [. . . ] Select a loop memory location that lights the caRD MeM LED. Press and hold the DeLete button for four seconds until EC (Erase Memory Card Loops) appears in the DIsPLaY and release (EL will show briefly first but keep holding the button until EC appears). The DeLete button will continue to flash. To abort this procedure, press the eXIt button. [. . . ]