User manual DIGITECH QUAD4

[. . . ] Pro gra m 55 4 IN R 1: CG S-DIS SIN ES PROC TM ev 2: Pl t 3: Dl y 4: GE Q dit FX E pare Com 4 O U T M U LT F I-E FE C TS PR O S CE SO R User's Manual Please visit Digitech Studio Electronics on the World Wide Web at: http://www. digitech. com IMPORTANT! CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN FOR YOUR PROTECTION, PLEASE READ THE FOLLOWING: WATER AND MOISTURE: Appliance should not be used near water (e. g. near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool, etc). Care should be taken so that objects do not fall and liquids are not spilled into the enclosure through openings. POWER SOURCES: The appliance should be connected to a power supply only of the type described in the operating instructions or as marked on the appliance. [. . . ] If you increase the feedback enough, the source begins to lose its own original pitch to the dramatic pitch modulation of the feedback loop. LFO Waveforms: There are four LFO waveforms available for Choruses, Flangers, Phasers, Tremolos, Auto Panners, and five for Modifier LFOs. They include SINe, TRIangle, SPecial-1, SPecial-2, and SPecial-3. Figure 3-4 shows of what these waveforms look like. AMPLITUDE (DEPTH) AMPLITUDE (DEPTH) AMPLITUDE (DEPTH) AMPLITUDE (DEPTH) FREQUENCY (SPEED) FREQUENCY (SPEED) FREQUENCY (SPEED) FREQUENCY (SPEED) AMPLITUDE (DEPTH) FREQUENCY (SPEED) SINE LFO TRIANGLE LFO SP1 LFO SP2 LFO SP3 LFO (Modifiers only) Figure 3-4 LFO Types Section 3 - Effects and Parameters Quad 4 User's Manual D ua lC h St er oru eo s Q ua Dua d l O Ch Cho ct or al us rus C ho ru s 19 DESCRIPTION Controls the signal input level fed to the Module. Controls the level of the dry (uneffected) signal. Controls the left/right positioning of the dry signal in the stereo soundfield. Varies from -99 (all left) to 99 (all right). Controls the Low Frequency Oscillator (LFO) speed of the chorus. Range of this control is from 0. 06 to 16 Hz. Adjusts the intensity of the chorus effect. High settings produce dramatic modulation, while lower settings can be used to produce a more subtle, ambient swirling. DEPTH1 adjusts the intensity of chorus voices 1-4. DEPTH2 adjusts the intensity of chorus voices 5-8. Ranges from 0 to 30 milliseconds. PARAM. FX: Lvl Dry: Lvl Choruses Balance Speed Depth Depth 1 - 2 Wander Speed Controls the secondary LFO speed of chorus voices 5-8. This is a secondary oscillator for voices 5-8 that causes deviations from the oscillation path set by DEPTH2. This control can produce radical new textures when used creatively. Try setting it slightly faster or slower than SPEED. Wander Depth Adjusts the intensity of the oscillation deviations produced by WANDER SPEED. WANDER DEPTH produces dramatic psycho-acoustic swirling effects when set higher than DEPTH2. WvFrm Selects which waveform the LFO follows. Options for this control include sine, triangle, SP1 (Special 1), and SP2 (Special 2). [. . . ] after which the unit resets, and returns to Program 1. In extreme situations, the Studio Quad 4 can be reset using a special power-up procedure. This will also completely reset the Studio Quad 4, eliminating any custom settings created by the user. Press and hold the <1> parameter button while powering-up to the Studio Quad 4. [. . . ]