User manual DIGITECH RP50

[. . . ] MODELING GUITAR PROCESSOR USER'S GUIDE Warning For your protection, please read the following: Water and Moisture: Appliances should not be used near water (e. g. near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool, etc. ) Care should be taken so that objects do not fall and liquids are not spilled into the enclosure through openings. These symbols are internationally accepted symbols taht warn of potential hazards with electrical products. The lightning flash means that there are dangerous voltages present within the unit. The exclamation point indicates that it is necessary for the user to refer to the owner's manual. [. . . ] The User Presets are locations where you may store presets you create. The Factory Presets may not be saved over. From the factory, the 40 User Presets are exact duplicates of the 40 Factory Presets. This lets you make your own presets without the worry of losing any Factory Presets. Play Mode When you first apply power to the RP50, it powers up in Play mode. The far left LED lights, indicating you're in Play mode. In Play mode, use the Up and Down Footswitches to access the presets. 8 Tuner The Tuner in the RP50 lets you quickly tune or check the tuning of your guitar. Enter the Tuner by pressing and holding both Footswitches simultaneously. The tu briefly displays indicating that you are in Tuner mode. To begin tuning, play a note on your guitar (the neck pickup usually works best). The display shows the note being played. The Effect LEDs indicate whether the note is sharp or flat. The right 6 red LEDs indicate the note is sharp and should be tuned down. The left 6 red LEDs indicate the note is flat and should be tuned up. The center Green LED indicates the note is in tune. As a button is pressed, the value or status is shown in the display. The EDIT/EFFECT buttons select which effect to edit. The VALUE/MASTER VOLUME buttons edit the selected effect. When the stored value of an effect is changed, the lower right decimal point in the display lights indicating you need to store the changes. Changing presets, or turning the power off before storing any changes will erase any changes made and revert to the stored values for the preset. 11 Storing/Copying a Preset Once the preset has been modified, you may store your settings to one of the 40 User Preset locations (Presets 1-40). The following steps outline how to store changes to a preset or copy a preset to a different location: 1. Press the STORE button again to save your changes. 2. Use the footswitches to select the preset location you want to store your changes to. 1. The current preset location flashes in the display. Press the FOOTSWITCHES to select the User Preset location. 3 Press the STORE button again to save the changes. 12 Effect Definitions The RP50 can be thought of as several different "virtual" amplifiers, and individual hi-tech effects. [. . . ] The reverb settings are as follows: r1-f9 = Room H1-H9 - Hall P1-p9 - Plate C1-C9=Church A1-a9 = Arena S1-s9 - Spring 19 Other Functions Expression Pedal The rear panel of the RP50 includes an input for an expression pedal. Any passive volume pedal can be used as an expression pedal with the RP50. Connect from the output of a passive volume pedal to the Expression Pedal Input on the RP50. The expression pedal controls the RP50's Volume, Wah, or WhammyTM parameters. [. . . ]