User manual DIGITECH TIME BENDER INSTALLATION

[. . . ] Master Time, Space, and Dimension Owner's Manual IMPORTANT SAFETY INFORMATION WarnInG for your ProtectIon reaD tHe foLLoWInG: KEEP THESE INSTRUCTIONS HEED ALL WARNINGS FOLLOW ALL INSTRUCTIONS the symbols shown above are internationally accepted symbols that warn of potential hazards with electrical products. the lightning flash with arrowpoint in an equilateral triangle means that there are dangerous voltages present within the unit. the exclamation point in an equilateral triangle indicates that it is necessary for the user to refer to the owner's manual. these symbols warn that there are no user serviceable parts inside the unit. [. . . ] To do this, step on both footswitches so that the Memory Indicator LED is not lit. Make sure the delay time is shown in seconds (where the decimal point is between the 1st and 2nd digits in the display) rather than beats per minute (where the decimal point is between the 3rd and 4th digits in the display). To switch between beats per minute and seconds, press and hold the Multiplier button for one second. Turn the Modulation knob all the way down (counter-clockwise). Turn the Pattern knob all the way down (counter-clockwise). Turn the Voicing knob to the left until U appears in the display. Set the Tone knob to the 12 o'clock position. Finally, make sure the multiplier is set to quarter notes. To do this, press and release the Multiplier button until the quarter note is selected. Select Digital Delay by turning the Delay Type knob all the way to the left. " " will appear briefly in the display. Adjust the Delay Time knob so that 0. 500 appears in the display. Set the Repeats knob to the 9 o'clock position. Set the Mix knob to the 12 o'clock position. Press and release the Delay On/Off footswitch so the On LED lights up. You should hear a simple delay. Try a Different Pattern 1. Turn the Pattern knob one click to the right. Play your guitar and note how the repeat pattern is different than before. 11 Tutorial Change the Multiplier Value 1. Press and release the Multiplier button one time, so the half note is selected. The delay time shown in the display should now be 1. 000. Notice how the repeats take twice as long as they did when the quarter note was selected. Now press and release the Multiplier button twice, so the eighth note is selected. [. . . ] To get the TimeBender back to what the controls show, make sure the Memory Indicator LED is lit (step on both footswitches if it isn't), then press and release the right footswitch until no Memory Location LED is lit. If you're using an expression pedal, unplug it when no Memory Location LED is lit to be sure the knobs reflect the true state of the TimeBender. When I strum a tempo or pattern, the key sometimes changes unexpectedly. Distortion pedals with extreme settings can boost hum and other noise that might be interpreted as a note. [. . . ]