User manual DIGITECH VOCAL 300

[. . . ] User's Guide Warning For your protection, please read the following: Water and Moisture: Appliances should not be used near water (e. g. near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool, etc. ) Care should be taken so that objects do not fall and liquids are not spilled into the enclosure through openings. These symbols are internationally accepted symbols that warn of potential hazards with electrical products. The lightning flash means that there are dangerous voltages present within the unit. The exclamation point indicates that it is necessary for the user to refer to the owners manual. These symbols warn that there are no user serviceable parts inside the unit. [. . . ] 7. While singing, gradually turn up the Vocal 300's INPUT GAIN knob until the INPUT CLIP LED lights with the strongest signals. Gradually bring the mixer's master fader up. Note: It may be necessary to consult your mixer's owners manual for the proper mixer setup. 3 Balanced XLR Cable 1/4" Stereo "Y" Cable or From Line Level Output MASTER Modes and Functions Performance Mode The Vocal 300 initially powers up in performance mode. Each press of this button moves to the next row of effects in the matrix. Press and hold this button to return to performance mode. STORE Button - Begins the storing process. INPUT GAIN knob - Sets the input gain for your microphone. LOW, MIDRANGE, HIGH, AND MASTER LEVEL Knobs - These knobs control the Bass, Mid Level, Treble, and Master Level of the presets. FOOTSWITCHES ­ The UP and DOWN footswitches move through the presets (1-40 User and 41-80 Factory). Pressing the BYPASS footswitch bypasses all effects. While in preset bypass, you can select the next preset using the UP and DOWN footswitches. This preset will then be loaded when bypass is exited. Expression Pedal - Controls the assigned parameter of the current preset. 4 Edit Mode The Vocal 300 lets you create your own presets, and modify existing presets. To create your own preset, do the following: 1. The Matrix's first effect row LED begins flashing. Modify the parameters in the selected row using the LOW, MIDRANGE, HIGH, and MASTER LEVEL knobs. When changes are made, the Store LED lights, and the abbreviated parameter name with a space followed by a two digit parameter value is displayed. To move to the next effect in the Matrix, press the SELECT button again. Press the STORE button to save your changes. Note: Pressing the UP or DOWN footswitches returns you to Performance mode. Pressing the BYPASS footswitch bypasses all effects. Store Mode After modifying a preset, you must store your settings to one of the 40 User Preset locations. To store changes to a preset or store a preset to a different location, do the following: 1. The Store LED begins blinking on and off, and the first character of the name flashes. [. . . ] High - Rotate the MASTER LEVEL knob to adjust the high frequency gain. Noise Gate The noise gate eliminates unwanted noise when a signal isn't present. Gate On/Off - Rotate the LOW knob to turn the noise gate on and off. Threshold - Rotate the MIDRANGE knob to select the noise gate's threshold. A higher setting requires a stronger signal to open the gate. Mod. Effects The Mod Effects module has several effects to choose from: Off, Chorus, Flanger, Phaser, Tremolo, Vibrato, Strobe, Doubler, Envelope, Pixelator, Detune, Pitch, and Whammy. [. . . ]