User manual DIGITECH VOCALIST LIVE 2 INSTALLATION

[. . . ] Vocal Harmony and Effects Processor Owner's Manual WARNING FOR YOUR PROTECTION PLEASE READ THE FOLLOWING: KEEP THESE INSTRUCTIONS HEED ALL WARNINGS FOLLOW ALL INSTRUCTIONS THE APPARATUS SHALL NOT bE ExPOSED TO DRIPPING OR SPLASHING LIqUID AND NO ObjECT FILLED WITH LIqUID, SUCH AS vASES, SHALL bE PLACED ON THE APPARATUS. DO NOT bLOCK ANY OF THE vENTILATION OPENINGS. INSTALL IN ACCORDANCE WITH THE MANUFACTURER'S INSTRUCTIONS. DO NOT INSTALL NEAR ANY HEAT SOURCES SUCH AS RADIATORS, HEAT REGISTERS, STOvES, OR OTHER APPARATUS (INCLUDING AMPLIFIERS) THAT PRODUCE HEAT. [. . . ] 5. Guitar Thru Connect a guitar amplifier or powered speaker directly to this output. Mic/Line Input Level This knob adjusts the gain of the Mic and Line inputs. Turn clockwise to increase gain, or counter-clockwise to decrease gain. If the Vocal Signal LED is turning red while you sing, you need to decrease the Mic gain. 6. 8. Mic In Connect a dynamic or condenser microphone to this XLR input. This input is the lead voice for the Vocalist® Live 2. Line In Connect a line input source (mixer, mic preamp, etc. ) to this input. When connected to a source, this input is the lead voice for the Vocalist Live 2, and disables the Mic In XLR input. Line Out L/R Connect these balanced/unbalanced outputs to a mixer, powered speakers or P. A. Only vocal, harmonies, and vocal effects are heard from the Line Outputs. Harmonies sent through these outputs are panned slightly to the left (Line Out L) and right (Line Out R). 9. Mono Out Connect this XLR balanced output to a powered speaker or mixer if a mono mix is desired. Only vocal, harmonies, and vocal effects are heard from this output. Connect only the DigiTech® PS0913B power supply to this jack. 10. Power Input 8 Getting Started Before connecting the Vocalist® Live 2, make sure that the power to your amplifier is off and that the Vocalist Live 2 is plugged into the wall and powered on. There is no power switch on the Vocalist Live 2. To turn the Vocalist Live 2 on or off, connect or disconnect the included PS0913B power supply from the Power Input jack. Connect the Microphone, Guitar, and P. A. Plug a microphone into the Vocalist Live 2 Mic In jack. If you need phantom power, press the Phantom Power switch on the Vocalist Live 2 back panel. Note: Phantom power is normally only needed with condenser microphones, and should never be used with ribbon microphones. To avoid damaging the microphone, please consult your microphone documentation to ensure phantom power is applied only when appropriate. Plug your guitar into the Vocalist Live 2 Guitar In jack. Make sure your guitar amplifier is turned off and the volume level is turned all the way down. Connect the Vocalist Live 2 Guitar Thru to your amplifier's input or the P. A. or mixer is turned off and the volume levels are turned all the way down. Plug the Vocalist Live 2 Left and Right Line Outputs into your P. A. [. . . ] If you have a volume control on your guitar (for example, an acoustic guitar with a pre-amp built in), you should adjust the volume so that the Guitar Signal LED is green or amber most of the time while playing. 21 Troubleshooting I don't hear any sound coming from the Vocalist® Live 2. · Make sure the power supply is plugged in to both the Vocalist Live 2 and the power outlet. system, or mixer is plugged in and turned on. system, or mixer volume levels aren't turned all the way down. [. . . ]